ISP1508AET NXP Semiconductors, ISP1508AET Datasheet - Page 44

no-image

ISP1508AET

Manufacturer Part Number
ISP1508AET
Description
RF Transceiver USB 2.0 ULPI TRNSCVR
Manufacturer
NXP Semiconductors
Datasheet

Specifications of ISP1508AET

Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
935283548118 ISP1508AET-T

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ISP1508AET
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
ISP1508AETT
Manufacturer:
ST
0
Part Number:
ISP1508AETTM
Quantity:
3 770
Part Number:
ISP1508AETTM
Manufacturer:
ST
Quantity:
20 000
NXP Semiconductors
ISP1508A_ISP1508B_1
Product data sheet
10.7.3 Remote wake-up
The ISP1508 supports peripherals that initiate remote wake-up resume. When placed into
USB suspend, the peripheral link remembers at what speed it was originally operating.
Depending on the original speed, the link follows one of the protocols detailed here. In
Figure
The sequence of events related to a host and a peripheral, both with ISP1508, is as
follows:
1. Both the host and the peripheral are assumed to be in low-power mode.
2. The peripheral begins remote wake-up by re-enabling its clock and setting its
3. The peripheral begins driving K on the bus to signal resume. Note that the peripheral
4. The host recognizes the resume, re-enables its clock and sets its SUSPENDM bit.
5. The host takes over resume driving within 1 ms of detecting the remote wake-up.
6. The peripheral stops driving resume.
7. The peripheral sees the host continuing to drive the resume.
8. The host stops driving resume and the ISP1508 automatically adds the EOP to the
9. Both the host and the peripheral revert to normal operation by writing 00b to
SUSPENDM bit to 1b.
link must assume that LINESTATE is K (01b) while transmitting because it will not
receive any RXCMDs.
end of the resume. The peripheral recognizes the EOP as the end of resume.
OPMODE. If the host or the peripheral was previously in high-speed mode, it must
revert to high-speed before the SE0 of the EOP is completed. This can be achieved
by writing XCVRSELECT[1:0] = 00b and TERMSELECT = 0b after LINESTATE
indicates SE0.
20, timing is not to scale, and not all RXCMD LINESTATE updates are shown.
Rev. 01 — 14 August 2007
ISP1508A; ISP1508B
ULPI HS USB transceiver
© NXP B.V. 2007. All rights reserved.
44 of 86

Related parts for ISP1508AET