SFPA8192Q1BO2TO-I-QT-223-STD Swissbit NA Inc, SFPA8192Q1BO2TO-I-QT-223-STD Datasheet - Page 6

• Manufacturer Part Number: SFPA8192Q1BO2TO-I-QT-223-STD
• Description: FLASH SSD SMART UDMA 2.5" 8GB
• Manufacturer: Swissbit NA Inc
• Series: P-120r

Specifications of SFPA8192Q1BO2TO-I-QT-223-STD

• Memory Size: 8GB
• Memory Type: FLASH
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 1052-1025

4.1 System Performance
4 Product Specification
The Solid State Drive (SSD) is a small form factor non-volatile memory drive which provides high capacity
data storage.
The drive with the IDE interface (2.00mm pitch) operates in three transfer modes:
The drive behaves as a standard ATA (IDE) disk drive. It can be set as master or slave by a jumper.
The drive has an internal intelligent controller which manages interface protocols, data storage and
retrieval as well as hardware RS-code Error Correction Code (ECC), defect handling, diagnostics and clock
control.
The wear leveling mechanism assures an equal usage of the Flash memory cells to extend the life time.
The hardware RS-code ECC allows to detect and correct 4 symbols per 528 Bytes.
The drive has a voltage detector and a powerful power-loss management feature to prevent data
corruption after power-down.
The specification has been realized and approved by the ATA/ATAPI-7 specification.
The system highlights are shown in Table 3 …Table 10.
Related Documentation
Table 3: System Performance
System Performance
Sleep to write
Sleep to read
Power-on to Ready
Reset to Ready
Data transfer Rate (UDMA4 burst)
Sustained Sequential Read (measured) UDMA4
128kB Block size
Sustained Sequential Write (measured) UDMA4
128kB Block size
Sustained Random Read (measured) UDMA4
4kB Block size
Sustained Random Write (measured) UDMA4
4kB Block size
Command to DRQ
Swissbit AG
Industriestrasse 4
CH-9552 Bronschhofen
Switzerland
1.
2.
3.
UDMA
MDMA (Multi Word Direct Memory Access)
PIO
Parallel Transport Protocols and Physical Interconnect (ATA/ATAPI-7)
AT Attachment Interface Document, American National Standards Institute, X3.221-1994
All values refer to Toshiba flash chips in UDMA4 mode with Sequential write/read test (256 sectors multiple commands) or
Random write/read test (8 sectors multiple commands) with Firmware 090617.
Sustained Speed depends on flash type and number, file size, and burst speed
In case of IDE-Master with no slave drive additional max. 500ms
In case of IDE-Master with additional slave drive depending on the slave handshaking (max. 31s)
(3)
(Ultra Direct Memory Access)
(Programmed Input / Output)
(3)
Swissbit reserves the right to change products or specifications without notice.
[e-mail]
www.swissbit.com
2..32GB
2..32GB
2..32GB
2..32GB
Write
Read
up to Mode 4
up to Mode 2
up to Mode 4
0.12
37
32
11
<500
Typ.
100
30
(1)(2)
(1)(2)
(1)(2)
66MB/s burst
16MB/s burst
16MB/s burst
(1)(2)
P-120_data_sheet_PA-QxBO_Rev100.doc
0.2
Max.
66
40
2000
1000
35
1000
15
500
5
5
(1)
(1)
(1)
(1)
(1)
Revision: 1.00
Page
MB/s
MB/s
Unit
ms
µs
6 of 76