ISP1582BS ST-Ericsson Inc, ISP1582BS Datasheet - Page 33

• Manufacturer Part Number: ISP1582BS
• Description: IC USB CTRL HI-SPEED 56HVQFN
• Manufacturer: ST-Ericsson Inc

Specifications of ISP1582BS

• Applications: USB Host/Peripheral Controller
• Interface: USB
• Voltage - Supply: 3 V ~ 3.6 V
• Package / Case: 56-VQFN Exposed Pad, 56-HVQFN, 56-SQFN, 56-DHVQFN
• Mounting Type: Surface Mount
• For Use With: ISP1582 PCI EVALKIT - PCI BUS EVAL KIT ISP1582
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

NXP Semiconductors
AN10039_4
Application note
5.1.3 Handling invalid CBW
5.1.4 Handling error
5.1.5 Handling CBW for an ATA device
A command block is invalid if it has an invalid CBW signature.
If the error_occur flag or transfer_error flag is set, the error must be handled, by stalling
the respective endpoint involved in the transfer.
CBW contains the ATAPI command embedded in the command block.
For an ATA device, the ATAPI packet command must be translated into an ATA
command, before it is issued to the device. The CBWCDB[0] field in CBW contains the
ATAPI command and the remaining field contains command parameters. Based on the
ATAPI command, the corresponding ATA command is selected and issued to the device.
1. Initialize the Endpoint Index register to the respective OUT endpoint.
2. Set the STALL bit in the Control Function register. When the host receives a stall, it
3. Initialize the Endpoint Index register to the respective OUT endpoint, and clear the
4. Set and reset the ENABLE bit in the Endpoint Type register. This will reset the data
5. Initialize the Endpoint Index register to 1 and set the STATUS bit in the Control
6. Wait till the EP0Tx interrupt is received.
7. Wait for the EP0SETUP interrupt, for the bulk-only mass storage reset command.
8. Initialize the Endpoint Index register, by setting the EP0SETUP bit in the Endpoint
9. Read the set-up buffer and re-initialize the ATA or ATAPI device, for a valid mass
• For the data OUT transfer, the respective OUT endpoint is stalled.
• For the data IN transfer, the respective IN endpoint is stalled.
• Clear the error_occur and transfer_error flags.
will send a clear feature command. Wait for the set-up token interrupt for the clear
feature.
STALL bit in the Control Function register.
toggle.
Function register
Index register.
storage reset command.
Rev. 04 — 21 December 2006
ISP1582/83 Firmware Programming Guide
AN10039
© NXP B.V. 2006. All rights reserved.
32 of 49