BC41B143A-ANN-E4 ETC, BC41B143A-ANN-E4 Datasheet - Page 46

• Manufacturer Part Number: BC41B143A-ANN-E4
• Description: Bluecore 4-rom CSP EDR Single Chip Bluetooth v2.0 + EDR System
• Manufacturer: ETC

10 Enhanced Data Rate
Enhanced Data Rate (EDR) has been introduced to provide 2x and 3x
higher layers of the Bluetooth stack. BlueCore4-ROM supports both of the new data rates and is compliant with
the Bluetooth v2.0 + EDR specification.
Note:
10.1
At the baseband level EDR utilises the same 1.6kHz slot rate and 1MHz symbol rate as the basic data rate.
Where EDR differs is that each symbol in the payload portion of a packet represents 2 or 3-bits. This is achieved
using two new distinct modulation schemes. These are summarised in Table 10.1 and in Figure 10.1.
Link establishment and management are unchanged and still use GFSK for both the header and payload portions
of these packets.
10.2
The 2x rate for EDR uses a π/4 DQPSK. Each symbol represents two bits of information. The constellation is
shown in Figure 10.2. It is described as having two places, each with four points. Although there appear to be
eight possible phase states, the encoding ensures that the trajectory of the modulation between symbols is
restricted to the four states in the other plane.
For a given starting point, each phase change between symbols is restricted to +3π/4, +π/4, -π/4 or -3π/4 radians
(+135°, +45°, -135° or -45°). For example, the arrows shown in Figure 10.2 represents trajectory to the four
possible states in the other plane. The phase shift encoding of symbols is shown in Table 10.2.
There are two primary advantages in using π/4-DQPSK modulation:
BC41B143A-ds-002Pd
(1)
!
!
Data Rate Scheme
The inclusion of 3x data rates is optional.
The scheme avoids crossing the origin (a +π or –π phase shift) and therefore minimises amplitude
variations in the envelope of the transmitted signal. This is in turn allows the RF power amplifiers of the
transmitter to be operated closer to their compression point without introducing spectral distortions.
Consequently, the DC to RF efficiency is maximised.
The differential encoding also allows for demodulation without the knowledge of an absolute value for
the phase of the RF carrier.
Basic Data Rate
Enhanced Data Rate Baseband
Enhanced Data Rate π/4 DQPSK
EDR
EDR
Figure 10.1: Basic Data Rate and Enhanced Data Rate Packet Types
This material is subject to CSR’s non-disclosure agreement
Table 10.1: Data Rate Schemes
© Cambridge Silicon Radio Limited 2005
Bits Per Symbol
Production Information
1
2
3
(1)
data rates with minimal disruption to
8DPSK (optional)
Modulation
π/4 DQPSK
GFSK
Enhanced Data Rate
Page 46 of 89