M3062GF8NGP#U5 Renesas Electronics America, M3062GF8NGP#U5 Datasheet - Page 205

MCU 3V 64K PB FREE 100-LQFP

M3062GF8NGP#U5

Manufacturer Part Number
M3062GF8NGP#U5
Description
MCU 3V 64K PB FREE 100-LQFP
Manufacturer
Renesas Electronics America
Series
M16C™ M16C/60r
Datasheet

Specifications of M3062GF8NGP#U5

Core Processor
M16C/60
Core Size
16-Bit
Speed
10MHz
Connectivity
SIO, UART/USART
Peripherals
DMA, WDT
Number Of I /o
85
Program Memory Size
64KB (64K x 8)
Program Memory Type
FLASH
Ram Size
8K x 8
Voltage - Supply (vcc/vdd)
2.7 V ~ 3.6 V
Data Converters
A/D 10x10b, D/A 2x8b
Oscillator Type
Internal
Operating Temperature
-20°C ~ 85°C
Package / Case
100-LQFP
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Eeprom Size
-

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
M3062GF8NGP#U5M3062GF8NGP
Manufacturer:
MITSUBISHI
Quantity:
20 000
Company:
Part Number:
M3062GF8NGP#U5M3062GF8NGP#D5
Manufacturer:
Renesas Electronics America
Quantity:
10 000
Company:
Part Number:
M3062GF8NGP#U5
Manufacturer:
Renesas Electronics America
Quantity:
10 000
Appendix Parallel I/O Mode (Flash Memory Version)
202
Rev.1.1
Parallel I/O Mode
The parallel I/O mode inputs and outputs the software commands, addresses and data needed to operate
(read, program, erase, etc.) the internal flash memory. This I/O is parallel.
Use an exclusive programer supporting M3062GF8N (flash memory version).
Refer to the instruction manual of each programer maker for the details of use.
User ROM and Boot ROM Areas
In parallel I/O mode, the user ROM and boot ROM areas shown in Figure 1.28.1 can be rewritten. Both
areas of flash memory can be operated on in the same way.
Program and block erase operations can be performed in the user ROM area. The user ROM area and its
blocks are shown in Figure 1.28.1.
The boot ROM area is 4 Kbytes in size. In parallel I/O mode, it is located at addresses 0FF000
0FFFFF
range. (Access to any location outside this address range is prohibited.)
In the boot ROM area, an erase block operation is applied to only one 4 Kbyte block. The boot ROM area
has had a standard serial I/O mode control program stored in it when shipped from the Mitsubishi factory.
Therefore, using the device in standard serial input/output mode, you do not need to write to the boot
ROM area.
16
. Make sure program and block erase operations are always performed within this address
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
M3062GF8NFP/GP
Mitsubishi microcomputers
16
through

Related parts for M3062GF8NGP#U5