M3062GF8NGP#U5 Renesas Electronics America, M3062GF8NGP#U5 Datasheet - Page 222

• Manufacturer Part Number: M3062GF8NGP#U5
• Description: MCU 3V 64K PB FREE 100-LQFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/60r

Specifications of M3062GF8NGP#U5

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 10MHz
• Connectivity: SIO, UART/USART
• Peripherals: DMA, WDT
• Number Of I /o: 85
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 100-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Appendix Standard Serial I/O Mode 1 (Flash Memory Version)
Rev.1.1
Table 1.32.2. Status register (SRD)
Status Register (SRD)
SRD0 bits
SR7 (bit7)
SR6 (bit6)
SR5 (bit5)
SR4 (bit4)
SR3 (bit3)
SR2 (bit2)
SR1 (bit1)
SR0 (bit0)
The status register indicates operating status of the flash memory and status such as whether an erase
operation or a program ended successfully or in error. It can be read by writing the read status register
command (70
Table 1.32.2 gives the definition of each status register bit. After clearing the reset, the status register
outputs “80
Sequencer status (SR7)
Erase Status (SR5)
Program Status (SR4)
After power-on, the sequencer status is set to 1(ready).
The sequencer status indicates the operating status of the device. This status bit is set to “0” (busy)
during write or erase operation and is set to 1 upon completion of these operations.
The erase status reports the operating status of the auto erase operation. If an erase error occurs, it is
set to “1”. When the erase status is cleared, it is set to “0”.
The program status reports the operating status of the auto write operation. If a write error occurs, it is
set to “1”. When the program status is cleared, it is set to “0”.
16
”.
16
). Also, the status register is cleared by writing the clear status register command (50
Sequencer status
Program status
Status name
Erase status
Reserved
Reserved
Reserved
Reserved
Reserved
Terminated in error
Terminated in error
Ready
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
“1”
-
-
-
-
-
Definition
Terminated normally
Terminated normally
M3062GF8NFP/GP
Mitsubishi microcomputers
Busy
“0”
-
-
-
-
-
16
).
219