R4F24269NVFQV Renesas Electronics America, R4F24269NVFQV Datasheet - Page 217

• Manufacturer Part Number: R4F24269NVFQV
• Description: MCU 256KB FLASH 64K 144-LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2400r

Specifications of R4F24269NVFQV

• Core Processor: H8S/2600
• Core Size: 16/32-Bit
• Speed: 33MHz
• Connectivity: EBI/EMI, I²C, IrDA, SCI, SSU, UART/USART
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 96
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 64K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

H8S/2426, H8S/2426R, H8S/2424 Group
6.4.2
The external address space bus specifications consist of five elements: bus width, number of
access states, number of program wait states, read strobe timing, and chip select (CS) assertion
period extension states. The bus width and number of access states for on-chip memory and
internal I/O registers are fixed, and are not affected by the bus controller.
(1)
A bus width of 8 or 16 bits can be selected with ABWCR. An area for which an 8-bit bus is
selected functions as an 8-bit access space, and an area for which a 16-bit bus is selected functions
as a 16-bit access space. If all areas are designated as 8-bit access space, 8-bit bus mode is set; if
any area is designated as 16-bit access space, 16-bit bus mode is set.
(2)
Two or three access states can be selected with ASTCR. An area for which 2-state access is
selected functions as a 2-state access space, and an area for which 3-state access is selected
functions as a 3-state access space. With the DRAM or synchronous DRAM interface and burst
ROM interface, the number of access states may be determined without regard to the setting of
ASTCR.
When 2-state access space is designated, wait insertion is disabled. When 3-state access space is
designated, it is possible to insert program waits by means of the WTCRA and WTCRB, and
external waits by means of the WAIT pin.
Note: The synchronous DRAM interface is not supported by the H8S/2426 Group and H8S/2424
(3)
When 3-state access space is designated by ASTCR, the number of program wait states to be
inserted automatically is selected with WTCRA and WTCRB. From 0 to 7 program wait states can
be selected. Table 6.2 shows the bus specifications (bus width, and number of access states and
program wait states) for each basic bus interface area.
REJ09B0466-0350 Rev. 3.50
Jul 09, 2010
Bus Width
Number of Access States
Number of Program Wait States
Group. The DRAM interface is not supported by the 5-V version.
Bus Specifications
Section 6 Bus Controller (BSC)
Page 187 of 1372