PIC16F724-E/MV Microchip Technology, PIC16F724-E/MV Datasheet - Page 37

• Manufacturer Part Number: PIC16F724-E/MV
• Description: 7KB Flash Program, 1.8V-5.5V, 16MHz Internal Oscillator, 8b ADC, CCP, I2C/SPI, A
• Manufacturer: Microchip Technology
• Series: PIC® XLP™ 16Fr

Specifications of PIC16F724-E/MV

• Processor Series: PIC16F
• Core: PIC
• Program Memory Type: Flash
• Program Memory Size: 7 KB
• Data Ram Size: 192 B
• Interface Type: I2C, SPI, AUSART
• Number Of Timers: 3
• Operating Supply Voltage: 1.8 V to 5.5 V
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Package / Case: UQFN-40
• Development Tools By Supplier: MPLAB IDE Software
• Minimum Operating Temperature: - 40 C
• Core Processor: PIC
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: I²C, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 36
• Eeprom Size: -
• Ram Size: 192 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 14x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Lead Free Status / Rohs Status: Details

3.5
Brown-out Reset is enabled by programming the
BOREN<1:0> bits in the Configuration register. The
brown-out trip point is selectable from two trip points
via the BORV bit in the Configuration register.
Between the POR and BOR, complete voltage range
coverage for execution protection can be imple-
mented.
Two bits are used to enable the BOR. When
BOREN = 11, the BOR is always enabled. When
BOREN = 10, the BOR is enabled, but disabled during
Sleep. When BOREN = 0X, the BOR is disabled.
FIGURE 3-3:
© 2009 Microchip Technology Inc.
Note 1: 64 ms delay only if PWRTE bit is programmed to ‘0’.
Brown-Out Reset (BOR)
Internal
Internal
Internal
Reset
Reset
Reset
V
V
V
DD
DD
DD
BROWN-OUT SITUATIONS
< 64 ms
PIC16F72X/PIC16LF72X
64 ms
If V
(T
tions”), the Brown-out situation will reset the device.
This will occur regardless of V
not ensured to occur if V
than parameter (T
If V
running, the chip will go back into a Brown-out Reset
and the Power-up Timer will be re-initialized. Once V
rises above V
64 ms Reset.
(1)
BOR
Note:
64 ms
64 ms
DD
DD
) (see Section 23.0 “Electrical Specifica-
drops below V
falls below V
(1)
(1)
When erasing Flash program memory, the
BOR is forced to enabled at the minimum
BOR setting to guarantee that any code
protection circuitry is operating properly.
BOR
, the Power-up Timer will execute a
BOR
BOR
BOR
).
DD
while the Power-up Timer is
for greater than parameter
falls below V
V
V
V
BOR
BOR
BOR
DD
slew rate. A Reset is
DS41341E-page 37
BOR
for more
DD