ISP1760ET,557 NXP Semiconductors, ISP1760ET,557 Datasheet - Page 102

no-image

ISP1760ET,557

Manufacturer Part Number
ISP1760ET,557
Description
Manufacturer
NXP Semiconductors
Datasheet

Specifications of ISP1760ET,557

Package Type
TFBGA
Pin Count
128
Lead Free Status / RoHS Status
Compliant
NXP Semiconductors
17. Soldering of through-hole mount packages
ISP1760_4
Product data sheet
17.1 Introduction to soldering through-hole mount packages
17.2 Soldering by dipping or by solder wave
17.3 Manual soldering
For further information on temperature profiles, refer to Application Note AN10365
“Surface mount reflow soldering description” .
This text gives a very brief insight into wave, dip and manual soldering.
Wave soldering is the preferred method for mounting of through-hole mount IC packages
on a printed-circuit board.
Driven by legislation and environmental forces the worldwide use of lead-free solder
pastes is increasing. Typical dwell time of the leads in the wave ranges from
3 seconds to 4 seconds at 250 C or 265 C, depending on solder material applied, SnPb
or Pb-free respectively.
The total contact time of successive solder waves must not exceed 5 seconds.
The device may be mounted up to the seating plane, but the temperature of the plastic
body must not exceed the specified maximum storage temperature (T
printed-circuit board has been pre-heated, forced cooling may be necessary immediately
after soldering to keep the temperature within the permissible limit.
Apply the soldering iron (24 V or less) to the lead(s) of the package, either below the
seating plane or not more than 2 mm above it. If the temperature of the soldering iron bit is
less than 300 C it may remain in contact for up to 10 seconds. If the bit temperature is
between 300 C and 400 C, contact may be up to 5 seconds.
Fig 25. Temperature profiles for large and small components
temperature
MSL: Moisture Sensitivity Level
Rev. 04 — 4 February 2008
= minimum soldering temperature
maximum peak temperature
minimum peak temperature
= MSL limit, damage level
Embedded Hi-Speed USB host controller
temperature
peak
stg(max)
© NXP B.V. 2008. All rights reserved.
ISP1760
001aac844
). If the
time
101 of 110

Related parts for ISP1760ET,557