STA310 STMicroelectronics, STA310 Datasheet - Page 13

• Manufacturer Part Number: STA310
• Description: IC AUDIO DECODER 6+2CH 80-TQFP
• Manufacturer: STMicroelectronics
• Type: Audio Decoderr

Specifications of STA310

• Applications: HDTV, Players, Receivers, Set-Top Boxes
• Voltage - Supply, Analog: 2.5V
• Voltage - Supply, Digital: 2.5V
• Mounting Type: Surface Mount
• Package / Case: 80-TQFP, 80-VQFP
• Audio Codec Type: MP3 Decoder
• No. Of Dacs: 3
• No. Of Input Channels: 2
• No. Of Output Channels: 6
• Adc / Dac Resolution: 32bit
• Sampling Rate: 192kHz
• Interface Type: I2C, Serial, Parallel
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8856; STA310

4.2.2.3 Word clock LRCLK
The frequency of LRCLK is given by:
No special configuration is required. The polarity can be changed in the register PCMCONF, by setting up the
field INV as needed.
4.3 Decoding states
There are two different decoder states: Idle state and decode state (see <Blue HT>Figure 3). To change states,
register
Figure 5. Decoding States
Idle Mode
This is the state entered after a hardware or software reset. In this state, the embedded DSP does not decode,
i.e. no data are processed. The chip is waiting for the RUN command, and during this state all configuration
registers must be initialized. In this state, even if the chip is not processing data, the DACs clocks can be output,
which enables to setup the external DACs. Once the PCMCLK, SCLK and LRCLK clocks are configured, it is-
possible to output them by setting the MUTE register.I
Table 2. Idle mode. play and mute commands effects
Note: 1. The PLAY command has no effect in this state as the decoder is not running. It can however be sent and it will be taken into account
Decode Mode
This state is entered after the RUN command has been sent (i.e. RUN register = 1). In this mode, the data are
processed. The decoder can play sound, or mute the outputs, by using the PLAY and MUTE registers:
- Flrclk = Fsclk/32; for 16 bit PCM output,
- Flrclk = Fsclk/64; for 18, 20 or 24 bits PCM output.
- To decode streams, the PLAY register must be set. When decoding, the sound will be sent to outputs
- To stop decoding, the PLAY register should be reset. Resuming decoding is performed by writing
if the MUTE register is reset. The outputs are muted if the MUTE register is set.
PLAY to 1 again
as soon as the decoder enters the decode state.
Play
X
X
Soft reset
Idle mode
Run command
Mute
0
1
Init mode
Clock (SCLK, LRCLK) State
Decoder ready to play sample
Not running
Running
Decode mode
Time
PCM Output
0
0
STA310
13/90