AD7193 Analog Devices, AD7193 Datasheet - Page 37

no-image

AD7193

Manufacturer Part Number
AD7193
Description
4-Channel, 4.8 kHz, Ultralow Noise, 24-Bit Sigma-Delta ADC with PGA
Manufacturer
Analog Devices
Datasheet

Specifications of AD7193

Resolution (bits)
24bit
# Chan
4
Sample Rate
n/a
Interface
Ser,SPI
Analog Input Type
Diff-Uni,SE-Uni,Usr-Defined Range/Offset
Ain Range
± (Vref/Gain)
Adc Architecture
Sigma-Delta
Pkg Type
SOP

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
AD7193BRUZ
Manufacturer:
ADI
Quantity:
1 000
Part Number:
AD7193BRUZ
Manufacturer:
ADI/亚德诺
Quantity:
20 000
Part Number:
AD7193BRUZ
Manufacturer:
ADI
Quantity:
5 643
Part Number:
AD7193BRUZ-REEL
Manufacturer:
ADI
Quantity:
1 000
Part Number:
AD7193BRUZ-REEL
Manufacturer:
ADI原装
Quantity:
20 000
Company:
Part Number:
AD7193BRUZ-REEL
Quantity:
5 000
Part Number:
AD7193BRUZ-SMD
Manufacturer:
TI
Quantity:
5 600
Data Sheet
Continuous Read
Rather than write to the communications register each time a
conversion is complete to access the data, the AD7193 can be
configured so that the conversions are placed on the DOUT/
RDY line automatically. By writing 01011100 to the communi-
cations register, the user need only apply the appropriate number
of SCLK cycles to the ADC, and the conversion word is auto-
matically placed on the DOUT/ RDY line when a conversion is
complete. The ADC should be configured for continuous
conversion mode.
When DOUT/ RDY goes low to indicate the end of a conversion,
sufficient SCLK cycles must be applied to the ADC; the data
conversion is then placed on the DOUT/ RDY line. When the
conversion is read, DOUT/ RDY returns high until the next
conversion is available. In this mode, the data can be read only
once. The user must also ensure that the data-word is read
before the next conversion is complete. If the user has not read
the conversion before the completion of the next conversion, or
if insufficient serial clocks are applied to the AD7193 to read
the word, the serial output register is reset when the next
conversion is complete, and the new conversion is placed in the
output serial register.
DOUT/RDY
SCLK
DIN
CS
0x5C
Figure 27. Continuous Read
Rev. C | Page 37 of 56
DATA
To exit the continuous read mode, Instruction 01011000 must
be written to the communications register while the RDY pin
is low. While in the continuous read mode, the ADC monitors
activity on the DIN line so that it can receive the instruction to
exit the continuous read mode. Additionally, a reset occurs if
40 consecutive 1s are seen on DIN. Therefore, DIN should be
held low in continuous read mode until an instruction is to be
written to the device.
When several channels are enabled, the ADC continuously
steps through the enabled channels and performs one conversion
on each channel each time that it is selected. DOUT/ RDY pulses
low when a conversion is available. When the user applies sufficient
SCLK pulses, the data is automatically placed on the DOUT/ RDY
pin. If the DAT_STA bit in the mode register is set to 1, the
contents of the status register are output along with the conversion.
The status register indicates the channel to which the conversion
corresponds.
DATA
DATA
AD7193

Related parts for AD7193