ST7FOXK1 STMicroelectronics, ST7FOXK1 Datasheet - Page 132

• Manufacturer Part Number: ST7FOXK1
• Description: Low cost flash 8bit micro
• Manufacturer: STMicroelectronics

Specifications of ST7FOXK1

• 4 To 8 Kbytes Single Voltage Extended Flash (xflash) Program Memory With Read-out Protection In-circuit Programming And In-application Programming (icp And Iap) Endurance: 1K write/erase cycles guaranteed Data retention
• Clock Sources: Internal trimmable 8 MHz RC oscillator, auto wakeup internal low power - low frequency oscillator, crystal/ceramic resonator or external clock
• Five Power Saving Modes: Halt, Active-Halt, Auto Wakeup from Halt, Wait and Slow
• A/d Converter: up to 10 input channels

On-chip peripherals
10.4.5
10.4.6
132/226
Interrupts
Table 43.
1. The 16-bit timer interrupt events are connected to the same interrupt vector (see
Summary of 16-bit timer modes
Table 44.
1. See note 4 in
2. See note 5 in
3. See note 4 in
Input capture 1 event/counter reset in PWM mode
Input capture 2 event
Output compare 1 event (not available in PWM mode)
Output compare 2 event (not available in PWM mode)
Timer overflow event
Input capture
Output compare
One pulse mode
PWM mode
These events generate an interrupt if the corresponding enable control bit is set and the interrupt mask in
the CC register is reset (RIM instruction).
Modes
16-bit timer interrupt control/wakeup capability
Summary of 16-bit timer modes
(1)
One pulse mode on page
One pulse mode on page
Pulse width modulation mode on page
and/or
(1)
Interrupt event
and/or
(2)
(2)
capture 1
Input
Yes
Yes
No
No
127.
127.
Not recommended
Not recommended
129.
capture 2
Input
Available resources
Yes
Yes
Event
OCF1
OCF2
ICF1
ICF2
TOF
flag
ST7FOXF1, ST7FOXK1, ST7FOXK2
control bit
(1)
(3)
Enable
OCIE
TOIE
ICIE
(1)
compare 1
Output
Section 7:
Yes
Yes
No
No
Exit from
WAIT
Yes
Yes
Yes
Yes
Yes
Interrupts).
compare 2
Partially
Output
Exit from
Yes
Yes
No
HALT
No
No
No
No
No
(2)