ST7FOXK1 STMicroelectronics, ST7FOXK1 Datasheet - Page 187

• Manufacturer Part Number: ST7FOXK1
• Description: Low cost flash 8bit micro
• Manufacturer: STMicroelectronics

Specifications of ST7FOXK1

• 4 To 8 Kbytes Single Voltage Extended Flash (xflash) Program Memory With Read-out Protection In-circuit Programming And In-application Programming (icp And Iap) Endurance: 1K write/erase cycles guaranteed Data retention
• Clock Sources: Internal trimmable 8 MHz RC oscillator, auto wakeup internal low power - low frequency oscillator, crystal/ceramic resonator or external clock
• Five Power Saving Modes: Halt, Active-Halt, Auto Wakeup from Halt, Wait and Slow
• A/d Converter: up to 10 input channels

ST7FOXF1, ST7FOXK1, ST7FOXK2
12
12.1
12.1.1
12.1.2
12.1.3
12.1.4
12.1.5
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
Typical values
Unless otherwise specified, typical data are based on T
4.5 V≤ V
tested.
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Figure 81. Pin loading conditions
Pin input voltage
The input voltage measurement on a pin of the device is described in
DD
≤ 5.5 V voltage range). They are given only as design guidelines and are not
C
L
ST7 PIN
A
A
= 25 °C and T
SS
= 25 °C, V
.
Electrical characteristics
DD
A
Figure
= 5 V (for the
= T
A
Figure
max (given by
82.
81.
187/226