LM3S1911-IRN20-A0T Luminary Micro, Inc., LM3S1911-IRN20-A0T Datasheet - Page 193

• Manufacturer Part Number: LM3S1911-IRN20-A0T
• Description: Microcontroller
• Manufacturer: Luminary Micro, Inc.

10
October 09, 2007
General-Purpose Timers
Programmable timers can be used to count or time external events that drive the Timer input pins.
The Stellaris
Timer 2, and Timer 3). Each GPTM block provides two 16-bit timer/counters (referred to as TimerA
and TimerB) that can be configured to operate independently as timers or event counters, or
configured to operate as one 32-bit timer or one 32-bit Real-Time Clock (RTC).
Note:
The General-Purpose Timer Module is one timing resource available on the Stellaris
Other timer resources include the System Timer (SysTick) (see “System Timer
(SysTick)” on page 35).
The following modes are supported:
■
■
■
■
32-bit Timer modes
–
–
–
–
16-bit Timer modes
–
–
–
–
16-bit Input Capture modes
–
–
16-bit PWM mode
–
Programmable one-shot timer
Programmable periodic timer
Real-Time Clock using 32.768-KHz input clock
Software-controlled event stalling (excluding RTC mode)
General-purpose timer function with an 8-bit prescaler (for one-shot and periodic modes only)
Programmable one-shot timer
Programmable periodic timer
Software-controlled event stalling
Input edge count capture
Input edge time capture
Simple PWM mode with software-programmable output inversion of the PWM signal
Timer2 is an internal timer and can only be used to generate internal interrupts.
®
General-Purpose Timer Module (GPTM) contains four GPTM blocks (Timer0, Timer1,
Preliminary
LM3S1911 Microcontroller
®
microcontrollers.
193