LAN9211_0711 SMSC [SMSC Corporation], LAN9211_0711 Datasheet - Page 63

• Manufacturer Part Number: LAN9211_0711
• Description: High-Performance Small Form Factor Single-Chip Ethernet Controller with HP Auto-MDIX
• Manufacturer: SMSC [SMSC Corporation]

High-Performance Small Form Factor Single-Chip Ethernet Controller with HP Auto-MDIX
Datasheet
SMSC
3.13.1.2
LAN9211
When performing a fast-forward, there must be at least 4 DWORDs of data in the RX data FIFO for
the packet being discarded. For less than 4 DWORDs do not use RX_FFWD. In this case data must
be read from the RX data FIFO and discarded using standard PIO read operations.
After initiating a fast-forward operation, do not perform any reads of the RX data FIFO until the
RX_FFWD bit is cleared. Other resources can be accessed during this time (i.e., any registers and/or
the other three FIFOs). Also note that the RX_FFWD will only fast-forward the RX data FIFO, not the
RX status FIFO.
The receiver does not have to be stopped to perform a fast-forward operation.
Force Receiver Discard (Receiver Dump)
In addition to the Receive data Fast Forward feature, LAN9211 also implements a receiver "dump"
feature. This feature allows the host processor to flush the entire contents of the RX data and RX
status FIFOs. When activated, the read and write pointers for the RX data and status FIFOs will be
returned to their reset state. To perform a receiver dump, the LAN9211 receiver must be halted. Once
the receiver stop completion is confirmed, the RX_DUMP bit can be set in the RX_CFG register. The
RX_DUMP bit is cleared when the dump is complete. For more information on stopping the receiver,
please refer to
on the RX_DUMP bit, please refer to
page
86.
Section 3.13.4, "Stopping and Starting the Receiver," on page
DATASHEET
Section 5.3.7, "RX_CFG—Receive Configuration Register," on
63
66. For more information
Revision 1.93 (11-27-07)