SE98ATP,547 NXP Semiconductors, SE98ATP,547 Datasheet - Page 39

• Manufacturer Part Number: SE98ATP,547
• Description: IC TEMP SENSOR DDR 8-HWSON
• Manufacturer: NXP Semiconductors

Specifications of SE98ATP,547

• Function: Temp Monitoring System (Sensor)
• Topology: ADC (Sigma Delta), Register Bank
• Sensor Type: Internal
• Sensing Temperature: -40°C ~ 125°C
• Output Type: I²C™/SMBus™
• Output Alarm: Yes
• Output Fan: Yes
• Voltage - Supply: 1.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-WSON (Exposed Pad), 8-HWSON
• Temperature Threshold: Programmable
• Full Temp Accuracy: +/- 1 C
• Digital Output - Bus Interface: 2-Wire, SMBus, I2C
• Digital Output - Number Of Bits: 11
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 1.7 V
• Description/function: DDR Memory Module Temperature Sensor
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Supply Current: 250 uA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-4731-2; SE98ATP,147

NXP Semiconductors
SE98A_4
Product data sheet
13.4 Reflow soldering
Key characteristics in reflow soldering are:
Table 28.
Table 29.
Moisture sensitivity precautions, as indicated on the packing, must be respected at all
times.
Studies have shown that small packages reach higher temperatures during reflow
soldering, see
Package thickness (mm)
< 2.5
≥ 2.5
Package thickness (mm)
< 1.6
1.6 to 2.5
> 2.5
•
•
•
Lead-free versus SnPb soldering; note that a lead-free reflow process usually leads to
higher minimum peak temperatures (see
reducing the process window
Solder paste printing issues including smearing, release, and adjusting the process
window for a mix of large and small components on one board
Reflow temperature profile; this profile includes preheat, reflow (in which the board is
heated to the peak temperature) and cooling down. It is imperative that the peak
temperature is high enough for the solder to make reliable solder joints (a solder paste
characteristic). In addition, the peak temperature must be low enough that the
packages and/or boards are not damaged. The peak temperature of the package
depends on package thickness and volume and is classified in accordance with
Table 28
SnPb eutectic process (from J-STD-020C)
Lead-free process (from J-STD-020C)
and
Figure
29
Rev. 04 — 25 November 2009
31.
Package reflow temperature (°C)
Volume (mm
< 350
235
220
Package reflow temperature (°C)
Volume (mm
< 350
260
260
250
DDR memory module temp sensor, 1.7 V to 3.6 V
3
3
)
)
Figure
350 to 2000
260
250
245
31) than a SnPb process, thus
≥ 350
220
220
> 2000
260
245
245
© NXP B.V. 2009. All rights reserved.
SE98A
39 of 43