ATMEGA64M1-AU Atmel, ATMEGA64M1-AU Datasheet - Page 297

• Manufacturer Part Number: ATMEGA64M1-AU
• Description: IC MCU AVR 64K FLASH 32TQFP
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA64M1-AU

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 16MHz
• Connectivity: CAN, LIN, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, Temp Sensor, WDT
• Program Memory Size: 64KB (32K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 2K x 8
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 11x10b; D/A 1x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 32-TQFP, 32-VQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Number Of I /o: -
• Lead Free Status / Rohs Status: Details

27.9.5
27.9.6
8209D–AVR–11/10
Programming the EEPROM
Reading the Flash
The EEPROM is organized in pages, see
EEPROM, the program data is latched into a page buffer. This allows one page of data to be
programmed simultaneously. The programming algorithm for the EEPROM data memory is as
follows (refer to
Data loading):
K: Repeat 3 through 5 until the entire buffer is filled
L: Program EEPROM page
Figure 27-4. Programming the EEPROM Waveforms
The algorithm for reading the Flash memory is as follows (refer to
page 295
RESET +12V
1. A: Load Command “0001 0001”
2. G: Load Address High Byte (0x00 - 0xFF)
3. B: Load Address Low Byte (0x00 - 0xFF)
4. C: Load Data (0x00 - 0xFF)
5. E: Latch data (give PAGEL a positive pulse)
1. Set BS1 to “0”
2. Give WR a negative pulse. This starts programming of the EEPROM page. RDY/BSY
3. Wait until to RDY/BSY goes high before programming the next page (see
1. A: Load Command “0000 0010”
2. G: Load Address High Byte (0x00 - 0xFF)
3. B: Load Address Low Byte (0x00 - 0xFF)
4. Set OE to “0”, and BS1 to “0”. The Flash word low byte can now be read at DATA
5. Set BS1 to “1”. The Flash word high byte can now be read at DATA
6. Set OE to “1”
RDY/BSY
PAGEL
XTAL1
DATA
goes low
for signal waveforms)
XA1
XA0
BS1
BS2
WR
OE
for details on Command and Address loading):
0x11
A
“Programming the Flash” on page 295
ADDR. HIGH
G
ADDR. LOW
B
DATA
C
Table 27-10 on page
XX
E
ATmega16M1/32M1/64M1
ADDR. LOW
B
for details on Command, Address and
DATA
C
K
XX
291. When programming the
E
“Programming the Flash” on
L
Figure 27-4
297