HD64F3067RF20 Renesas Electronics America, HD64F3067RF20 Datasheet - Page 545

• Manufacturer Part Number: HD64F3067RF20
• Description: IC H8 MCU FLASH 128K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300Hr

Specifications of HD64F3067RF20

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: SCI, SmartCard
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 70
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 100-QFP
• Package: 100PQFP
• Family Name: H8
• Maximum Speed: 20 MHz
• Operating Supply Voltage: 5 V
• Data Bus Width: 16|32 Bit
• Number Of Programmable I/os: 70
• Interface Type: SCI
• On-chip Adc: 8-chx10-bit
• On-chip Dac: 2-chx8-bit
• Number Of Timers: 7
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Clear DR bit to 0 and set DDR to 1
Write transmit data in TDR
and set MPBT bit in SSR
Clear TE bit to 0 in SCR
Read TDRE flag in SSR
Read TEND flag in SSR
Output break signal?
All data transmitted?
Figure 13.10 Sample Flowchart for Transmitting Multiprocessor Serial Data
Clear TDRE flag to 0
Start transmitting
TDRE = 1
TEND = 1
Initialize
<End>
Yes
Yes
Yes
Yes
No
No
No
No
(4)
(1)
(2)
(3)
(1)
(2)
(3)
(4)
SCI initialization:
the transmit data output function of the TxD pin
is selected automatically.
SCI status check and transmit data write:
read SSR, check that the TDRE flag is 1, then
write transmit data in TDR. Also set the MPBT
flag to 0 or 1 in SSR. Finally, clear the TDRE
flag to 0.
To continue transmitting serial data:
after checking that the TDRE flag is 1,
indicating that data can be written, write data
in TDR, then clear the TDRE flag to 0. When
the DMAC is activated by a transmit-data-
empty interrupt request (TXI) to write data in
TDR, the TDRE flag is checked and cleared
automatically.
To output a break signal at the end of serial
transmission:
set the DDR bit to 1 and clear the DR bit to 0,
then clear the TE bit to 0 in SCR.
Section 13 Serial Communication Interface
Rev. 4.00 Jan 26, 2006 page 521 of 938
REJ09B0276-0400