Z8F6401AN020SC00TR Zilog, Z8F6401AN020SC00TR Datasheet - Page 83

• Manufacturer Part Number: Z8F6401AN020SC00TR
• Description: IC ENCORE MCU FLASH 64K 44LQFP
• Manufacturer: Zilog
• Series: Encore!®r

Specifications of Z8F6401AN020SC00TR

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, DMA, POR, PWM, WDT
• Number Of I /o: 31
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 44-LQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: Z8F6401AN020SC00T

PS017610-0404
2. Write to the Timer High and Low Byte registers to set the starting count value. This
3. Write to the Timer Reload High and Low Byte registers to set the Reload value.
4. If desired, enable the timer interrupt and set the timer interrupt priority by writing to
5. Configure the associated GPIO port pin for the Timer Input alternate function.
6. Write to the Timer Control register to enable the timer.
7. Assert the Timer Input signal to initiate the counting.
Capture/Compare Mode
In Capture/Compare mode, the timer begins counting on the first external Timer Input
transition. The desired transition (rising edge or falling edge) is set by the TPOL bit in the
Timer Control Register. The timer input is the system clock.
Every subsequent desired transition (after the first) of the Timer Input signal captures the
current count value. The Capture value is written to the Timer PWM High and Low Byte
Registers. When the Capture event occurs, an interrupt is generated, the count value in the
Timer High and Low Byte registers is reset to
If no Capture event occurs, the timer counts up to the 16-bit Compare value stored in the
Timer Reload High and Low Byte registers. Upon reaching the Compare value, the timer
generates an interrupt, the count value in the Timer High and Low Byte registers is reset to
0001H and counting resumes.
The steps for configuring a timer for Capture/Compare mode and initiating the count are
as follows:
1. Write to the Timer Control register to:
2. Write to the Timer High and Low Byte registers to set the starting count value
3. Write to the Timer Reload High and Low Byte registers to set the Compare value.
4. If desired, enable the timer interrupt and set the timer interrupt priority by writing to
–
–
only affects the first pass in Gated mode. After the first timer reset in Gated mode,
counting always begins at the reset value of
the relevant interrupt registers.
–
–
–
–
(typically
the relevant interrupt registers.
Configure the timer for Gated mode.
Set the prescale value.
Disable the timer
Configure the timer for Capture/Compare mode.
Set the prescale value.
Set the Capture edge (rising or falling) for the Timer Input.
0001H
).
Z8F640x/Z8F480x/Z8F320x/Z8F240x/Z8F160x
0001H
0001H
, and counting resumes.
.
Z8 Encore!
Timers
®
65