T89C51RD2-3CBC-L ATMEL [ATMEL Corporation], T89C51RD2-3CBC-L Datasheet - Page 32

• Manufacturer Part Number: T89C51RD2-3CBC-L
• Description: 0 to 40MHz Flash Programmable 8-bit Microcontroller
• Manufacturer: ATMEL [ATMEL Corporation]

6.6. Serial I/O Port
The serial I/O port in the T89C51RD2 is compatible with the serial I/O port in the 80C52.
It provides both synchronous and asynchronous communication modes. It operates as an Universal Asynchronous
Receiver and Transmitter (UART) in three full-duplex modes (Modes 1, 2 and 3). Asynchronous transmission and
reception can occur simultaneously and at different baud rates
Serial I/O port includes the following enhancements:
6.6.1. Framing Error Detection
Framing bit error detection is provided for the three asynchronous modes (modes 1, 2 and 3). To enable the framing
bit error detection feature, set SMOD0 bit in PCON register (See Figure 13).
When this feature is enabled, the receiver checks each incoming data frame for a valid stop bit. An invalid stop
bit may result from noise on the serial lines or from simultaneous transmission by two CPUs. If a valid stop bit
is not found, the Framing Error bit (FE) in SCON register (See Table 15.) bit is set.
Software may examine FE bit after each reception to check for data errors. Once set, only software or a reset can
clear FE bit. Subsequently received frames with valid stop bits cannot clear FE bit. When FE feature is enabled,
RI rises on stop bit instead of the last data bit (See Figure 14. and Figure 15.).
Rev. F - 15 February, 2001
Framing error detection
Automatic address recognition
SMOD0=X
SMOD0=1
SM0/FE
SMOD1
RXD
FE
RI
SMOD0
SM1
Figure 13. Framing Error Block Diagram
Start
bit
SM2
Figure 14. UART Timings in Mode 1
-
D0
REN
Set FE bit if stop bit is 0 (framing error) (SMOD0 = 1)
SM0 to UART mode control (SMOD0 = 0)
POF
To UART framing error control
D1
TB8
GF1
D2
RB8
GF0
D3
Data byte
D4
PD
TI
D5
IDL
RI
D6
SCON (98h)
PCON (87h)
D7
T89C51RD2
Stop
bit
32