LPC11U35FHI33/501, NXP Semiconductors, LPC11U35FHI33/501, Datasheet - Page 19

• Manufacturer Part Number: LPC11U35FHI33/501,
• Description: ARM Microcontrollers - MCU 32-bit ARM Cortex-M0 64KB Flash 12KB SRAM
• Manufacturer: NXP Semiconductors

Specifications of LPC11U35FHI33/501,

• Rohs: yes
• Core: ARM Cortex M0
• Processor Series: LPC11U3x
• Data Bus Width: 32 bit
• Maximum Clock Frequency: 50 MHz
• Program Memory Size: 64 KB
• Data Ram Size: 12 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 1.8 V to 3.6 V
• Operating Temperature Range: - 40 C to + 85 C
• Package / Case: HVQFN-32
• Mounting Style: SMD/SMT
• Factory Pack Quantity: 490

NXP Semiconductors
LPC11U3X
Product data sheet
7.9.1.1 Features
7.8.1 Features
7.9.1 Full-speed USB device controller
7.10 USART
7.9 USB interface
The Universal Serial Bus (USB) is a 4-wire bus that supports communication between a
host and one or more (up to 127) peripherals. The host controller allocates the USB
bandwidth to attached devices through a token-based protocol. The bus supports
hot-plugging and dynamic configuration of the devices. The host controller initiates all
transactions.
The LPC11U3x USB interface consists of a full-speed device controller with on-chip PHY
(PHYsical layer) for device functions.
Remark: Configure the LPC11U3x in default power mode with the power profiles before
using the USB (see
efficiency, or low-power mode.
The device controller enables 12 Mbit/s data exchange with a USB Host controller. It
consists of a register interface, serial interface engine, and endpoint buffer memory. The
serial interface engine decodes the USB data stream and writes data to the appropriate
endpoint buffer. The status of a completed USB transfer or error condition is indicated via
status registers. If enabled, an interrupt is generated.
The LPC11U3x contains one USART.
The USART includes full modem control, support for synchronous mode, and a smart
card interface. The RS-485/9-bit mode allows both software address detection and
automatic address detection using 9-bit mode.
•
•
•
•
•
•
•
•
•
•
•
•
GPIO pins can be configured as input or output by software.
All GPIO pins default to inputs with interrupt disabled at reset.
Pin registers allow pins to be sensed and set individually.
Up to eight GPIO pins can be selected from all GPIO pins to create an edge- or
level-sensitive GPIO interrupt request.
Any pin or pins in each port can trigger a port interrupt.
Dedicated USB PLL available.
Fully compliant with USB 2.0 specification (full speed).
Supports 10 physical (5 logical) endpoints including one control endpoint.
Single and double buffering supported.
Each non-control endpoint supports bulk, interrupt, or isochronous endpoint types.
Supports wake-up from Deep-sleep mode and Power-down mode on USB activity
and remote wake-up.
Supports SoftConnect.
All information provided in this document is subject to legal disclaimers.
Section
Rev. 1 — 20 April 2012
7.17.5.1). Do not use the USB with the part in performance,
32-bit ARM Cortex-M0 microcontroller
LPC11U3x
© NXP B.V. 2012. All rights reserved.
19 of 70