HD64F2623FA20J Renesas Electronics America, HD64F2623FA20J Datasheet - Page 607

• Manufacturer Part Number: HD64F2623FA20J
• Description: IC H8S MCU FLASH 256K 100-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2623FA20J

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SmartCard
• Peripherals: POR, PWM, WDT
• Number Of I /o: 53
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 12K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 100-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 15 Controller Area Network (HCAN)
HCAN sleep mode is entered by setting the HCAN sleep mode bit (MCR5) to 1 in the master
control register (MCR). If the CAN bus is operating, the transition to HCAN sleep mode is
delayed until the bus becomes idle.
Either of the following methods of clearing HCAN sleep mode can be selected by making a setting
in the MCR7 bit.
1. Clearing by software
2. Clearing by CAN bus operation
Eleven recessive bits must be received after HCAN sleep mode is cleared before CAN bus
communication is enabled again.
Clearing by software: HCAN sleep mode is cleared by writing a 0 to MCR5 from the CPU.
Clearing by CAN bus operation: Clearing by CAN bus operation occurs automatically when the
CAN bus performs an operation and this change is detected. In this case, the first message is not
received in the mailbox, and normal reception starts from the next message. When a change is
detected on the CAN bus in HCAN sleep mode, the bus operation interrupt flag (IRR12) is set in
the interrupt register (IRR). If the bus interrupt mask (IMR12) in the interrupt mask register (IMR)
is set to the interrupt enable value at this time, an interrupt can be sent to the CPU.
Rev. 5.00 Jan 10, 2006 page 581 of 1042
REJ09B0275-0500