L6460 STMicroelectronics, L6460 Datasheet - Page 50

• Manufacturer Part Number: L6460
• Description: MOSFET & Power Driver ICs SPI Config Stepper DC Multi Motor DRV
• Manufacturer: STMicroelectronics
• Type: Full-Bridge Driverr

Specifications of L6460

• Product: Half-Bridge Drivers
• Rise Time: 0.4 us
• Fall Time: 0.4 us
• Supply Voltage (max): 38 V
• Supply Voltage (min): 13 V
• Supply Current: 11 mA
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Number Of Drivers: 4
• Output Current: 10 mA
• Output Voltage: 30 V
• Package / Case: TQFP-64
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Main switching regulator
12
12.1
50/139
Main switching regulator
Main switching regulator is an asynchronous switching regulator intended to be the source
of the main voltage in the system. It implements a soft start strategy and could be a system
regulator so even if its output voltage V
L6460 will check that it is in the good value range before enabling all its internal functions.
When L6460 detects a system regulator under-voltage event with a duration longer than the
period defined by the deglitch filter (t
the microcontroller by pulling low the nRESET pin and disabling most of its internal block
(e.g. bridges, GPIOs, …).
The output voltage will be externally set by a divider network connected to feedback pin. To
reduce as much as possible the regulation voltage error L6460 has the possibility to choose
between four feedback voltage references (and, as a consequence, four under-voltage
thresholds) using the serial interface. The feedback reference voltage selection is made by
writing the SelFBRef bits in the MainSwCfg register.
Here after are summarized the primary features of this regulator:
When L6460 is in “low power mode”, this regulator will be disabled.
In order to save external components and power when using two or more L6460 IC’s on the
same board, the primary switching regulator can be disabled by serial interface. Care must
be paid using this function because an under-voltage on this regulator, as previously seen,
will be read as a fault condition by L6460.
Pulse skipping operation
Pulse skipping is a well known, non linear, control strategy used in switching regulators.
In this technique (see
beginning of each switching cycle. At this time, if the sampled value shows that output
voltage is lower than requested one, the complete PWM duty cycle is applied to power
switch; otherwise no PWM is applied and the switching cycle is skipped. Once PWM is
applied to power element only a current limit event can disable the power switch before the
whole duty cycle is finished.
–
–
–
–
–
–
–
Internal power switch.
Soft start circuitry to limit inrush current flow from primary supply.
Internally generated PWM (250 kHz switching frequency).
Nonlinear pulse skipping control.
Protected against load short circuit.
Cycle by cycle current limiting using internal current sensor.
Under voltage signal (both continuous and latched) accessible through SPI.
Figure
11) the feedback comparator output is sampled at the
Doc ID 17713 Rev 1
prim_uv
SWmain
), it will enter in reset state signaling this event to
is not used to power any internal circuit,
L6460