L6460 STMicroelectronics, L6460 Datasheet - Page 92

• Manufacturer Part Number: L6460
• Description: MOSFET & Power Driver ICs SPI Config Stepper DC Multi Motor DRV
• Manufacturer: STMicroelectronics
• Type: Full-Bridge Driverr

Specifications of L6460

• Product: Half-Bridge Drivers
• Rise Time: 0.4 us
• Fall Time: 0.4 us
• Supply Voltage (max): 38 V
• Supply Voltage (min): 13 V
• Supply Current: 11 mA
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• Number Of Drivers: 4
• Output Current: 10 mA
• Output Voltage: 30 V
• Package / Case: TQFP-64
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Interrupt controller
92/139
Table 36.
1. This event is disabled if the related ADC channel is configured in continuous mode.
Any event detection can be enabled and disabled by setting at logic level 1 the relative
enable bit in the interrupt controller configuration register (IntCrtlCfg).
The interrupt controller can be programmed to give a pulse when a monitored event
happens or to continuously maintaining the output active until the interrupt condition is
finished.
When programmed to signal the enabled events by giving pulses, the interrupt controller can
be configured to disable the event that caused the interrupt request until the firmware re-
enables it writing the relative bit in the control register (IntCrtlCtrl) or to continue to monitor
the event.
The GPIO output of this circuit can be programmed to be active high or active low.
ADCDone1
ADCDone2
Vloop1Ilim
WDWarn
DigCmp
Event
WD
Interrupt controller event (continued)
Watch dog warning event
Watch dog event
Digital comparator
ADC conversion done 1
ADC conversion done 2
AUX1 Ilimit event.
Doc ID 17713 Rev 1
Event description
Notes
(1)
(1)
L6460