CS42428-CQZ Cirrus Logic Inc, CS42428-CQZ Datasheet - Page 38

• Manufacturer Part Number: CS42428-CQZ
• Description: IC CODEC 8CH PLL 192KHZ 64-LQFP
• Manufacturer: Cirrus Logic Inc
• Type: Audio Codecr

Specifications of CS42428-CQZ

• Data Interface: Serial
• Resolution (bits): 24 b
• Number Of Adcs / Dacs: 2 / 8
• Sigma Delta: Yes
• Dynamic Range, Adcs / Dacs (db) Typ: 114 / 114
• Voltage - Supply, Analog: 4.75 V ~ 5.25 V
• Voltage - Supply, Digital: 3.13 V ~ 5.25 V
• Operating Temperature: -10°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 64-LQFP
• Audio Codec Type: Stereo
• No. Of Adcs: 2
• No. Of Dacs: 8
• No. Of Input Channels: 2
• No. Of Output Channels: 15
• Adc / Dac Resolution: 24bit
• Sampling Rate: 192kSPS
• Ic Interface Type: I2C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1499 - BOARD EVAL FOR CS42428 CODEC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 598-1031

CS42428
4.9
Power Supply, Grounding, and PCB Layout
As with any high-resolution converter, the CS42428 requires careful attention to power supply and ground-
ing arrangements if its potential performance is to be realized. Figure
5
and
6
show the recommended power
arrangements, with VA connected to clean supplies. VD, which powers the digital circuitry, may be run from
the system logic supply. Alternatively, VD may be powered from the analog supply via a ferrite bead. In this
case, no additional devices should be powered from VD.
For applications where the output of the PLL is required to be low jitter, use a separate, low-noise analog
+5 V supply for VA, decoupled to AGND. In addition, a separate region of analog ground plane around the
FILT+, VQ, LPFLT, REFGND, AGND, and VA pins is recommended.
Extensive use of power and ground planes, ground plane fill in unused areas and surface mount decoupling
capacitors are recommended. Decoupling capacitors should be as near to the pins of the CS42428 as pos-
sible. The low value ceramic capacitor should be the nearest to the pin and should be mounted on the same
side of the board as the CS42428 to minimize inductance effects. All signals, especially clocks, should be
kept away from the FILT+, VQ and LPFLT pins in order to avoid unwanted coupling into the modulators and
PLL. The FILT+ and VQ decoupling capacitors, particularly the 0.1 µF, must be positioned to minimize the
electrical path from FILT+ and REFGND. The CDB42428 evaluation board demonstrates the optimum lay-
out and power supply arrangements.
38
DS605F1