S5920Q Applied Micro Circuits Corporation, S5920Q Datasheet - Page 88

• Manufacturer Part Number: S5920Q
• Manufacturer: Applied Micro Circuits Corporation

Specifications of S5920Q

• Operating Temperature (min): 0C
• Operating Temperature Classification: Commercial
• Operating Temperature (max): 70C
• Package Type: PQFP
• Rad Hardened: No
• Lead Free Status / Rohs Status: Not Compliant

S5920 – PCI Product: Operation Registers
Table 47. Reset General Control/Status Register
AMCC Confidential and Proprietary
31:29
23:16
15:12
11:0
Bit
28
27
26
25
24
nvRAM Access Control. This field provides a method for access to the optional external non-volatile memory.
Write operations are achieved by a sequence of byte operations involving these bits and the 8-bit field of bits 23
through 16. The sequence requires that the low-order address, high-order address, and then a data byte are
loaded in order. Bit 31 of this field acts as a combined enable and ready for the access to the external memory.
D31 must be set to a 1 before an access can begin, and subsequent accesses must wait for bit D31 to become
0 (ready).
D31
Cautionary note: The non-volatile memory interface is also available for access by the Add-On interface. While
simultaneous accesses to the nv memory by both the Add-On and PCI are supported, via arbitration logic, soft-
ware must be designed to prevent the possibility of data corruption within the memory and to provide for accu-
rate data retrieval.
nvRAM Access Failed. It will indicate that the last nvRAM access has failed. This flag is cleared automatically
upon the start of the next read/write operation.
Mailbox Flag Reset. Writing a one to this bit causes all mailbox status flags to become reset (EMPTY). It is not
necessary to write this bit to 0 afterwards because it is used internally to produce a reset pulse. Since reading
this bit will always return a 0, this bit is write only.
Reserved. Always zero.
Read FIFO Reset. Writing a one to this bit causes the read FIFO to reset (empty). It is not necessary to write a
0 to this bit. This bit is write only. This feature is intended for test only. It can only be asserted when the PCI is
not performing any Pass-Thru accesses.
Reserved. Always zero.
Non-volatile Memory Address/Data Port. This 8-bit field is used in conjunction with bits 31, 30 and 29 of this reg-
ister to access the external non-volatile memory. The contents written are either low address, high address, or
data as defined by bits 30 and 29. This register will contain the external non-volatile memory data when the
proper read sequence for bits 31 through 29 is performed.
BIST Condition Code. This field is directly connected to the PCI configuration self-test register. Bit 15 through 12
maps with the BIST register bits 3 through 0, respectively.
Reserved. Always zero.
0
1
1
1
1
0
1
D30
X
X
X
0
0
1
1
D29
X
X
X
0
1
0
1
W/R
W
W
W
W
W
R
R
Inactive
Load low address byte
Load high address
Begin write
Begin read
Ready
Busy
Description
Revision 1.02 – April 12, 2007
Data Book
DS1596
88