S9S12P64J0CFTR Freescale Semiconductor, S9S12P64J0CFTR Datasheet - Page 200

• Manufacturer Part Number: S9S12P64J0CFTR
• Description: 16-bit Microcontrollers - MCU 16-bit 64K Flash
• Manufacturer: Freescale Semiconductor

Specifications of S9S12P64J0CFTR

• Rohs: yes
• Core: S12
• Processor Series: MC9S12P
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 25 MHz
• Program Memory Size: 64 KB
• Data Ram Size: 4 KB
• On-chip Adc: Yes
• Operating Supply Voltage: 3.15 V to 5.5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: QFN-48
• Mounting Style: SMD/SMT

S12 Clock, Reset and Power Management Unit (S12CPMU)
7.1.2.3
This mode is entered by executing the CPU STOP instruction.
The voltage regulator is in Reduced Power Mode (RPM).
The API is available.
The Phase Locked Loop (PLL) is off.
The Internal Reference Clock (IRC1M) is off.
Core Clock, Bus Clock and BDM Clock are stopped.
Depending on the setting of the PSTP and the OSCE bit, Stop Mode can be differentiated between Full
Stop Mode (PSTP = 0 or OSCE=0) and Pseudo Stop Mode (PSTP = 1 and OSCE=1).
200
•
•
Full Stop Mode (PSTP=0 or OSCE=0)
The external oscillator (OSCLCP) is disabled.
After wake-up from Full Stop Mode the Core Clock and Bus Clock are running on PLLCLK
(PLLSEL=1). After wake-up from Full Stop Mode COP and RTI are running on IRCCLK
(COPOSCSEL=0, RTIOSCSEL=0).
Pseudo Stop Mode (PSTP=1 and OSCE=1)
The external oscillator (OSCLCP) continues torun. If the respective enable bits are set the COP and
RTI will continue to run.
The clock configuration bits PLLSEL, COPOSCSEL, RTIOSCSEL are unchanged.
Stop Mode
When starting up the external oscillator (either by programming OSCE bit
to 1 or on exit from Full Stop Mode with OSCE bit already 1) the software
must wait for a minimum time equivalent to the startup-time of the external
oscillator t
UPOSC
before entering Pseudo Stop Mode.
S12P-Family Reference Manual, Rev. 1.13
NOTE
Freescale Semiconductor