ST92E163-EPB/US STMicroelectronics, ST92E163-EPB/US Datasheet - Page 142

• Manufacturer Part Number: ST92E163-EPB/US
• Description: KIT DEMO MASS STORAGE
• Manufacturer: STMicroelectronics
• Type: Microcontroller Programmerr

Specifications of ST92E163-EPB/US

• Contents: Programmer, Cable, Power Supply, Software, Manual and more
• For Use With/related Products: ST9 MCUs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST92163R4 - USB PERIPHERAL (USB)
USB INTERFACE (Cont’d)
Bit 0 = Reserved. This bit is fixed by hardware at 0.
INTERRUPT STATUS REGISTER (USBISTR)
R249 - Read/Write
Register page: 15
Reset Value: 0000 0000 (00h)
Each bit is set by hardware when the related event
occurs.
If one of these bits is set, the hardware clears the
CTRO bit and sets the V[3:0] bits in the USBIVR
register. In this way the USBIVR register will point
to the interrupt vector containing the address of
the service routine related to these interrupt sourc-
es. If several bits are set only a single interrupt will
be generated.
Note: to avoid spurious clearing of some bits, it is
recommended to clear them with a load instruction
where all bits which must not be altered are set to
1, and all bits to be cleared are set to 0. Read-
modify-write instructions like AND, XOR,... are to
be avoided: consider the case of clearing bit 0 of
USBISTR with an AND instruction, when only bit 7
of USBISTR is at 1 and the others at 0. First the
microcontroller reads the content of USBISTR
(=10h), then it clears bit 7 and writes the result
(=00h) in USBISTR. If between the read and the
write operations another bit were set by hardware
(e.g. bit 5), writing 00h would clear it before the mi-
croprocessor has the time to service the event.
Table 26. Classification of Interrupt Sources:
142/230
Interrupt
7
0 DOVR
DOVR
ERR
ESUSP
SUSP
RESET
SOF
ESOF
ERR
ESUSP
Class
DMA Over/Underrun event
Notification event
Notification event
Notification event
Notification event
Notification event
Notification event
SUSP
RESET
SOF
ESOF
0
Bit 7 = Reserved. This bit is fixed by hardware at 0.
Bit 6 = DOVR: DMA over/underrun.
ST9 processor has not been able to answer a
DMA request in time and the USB FIFO buffer is
full or empty depending on the transfer direction
(reception or transmission).
The USB handles this event in the following way:
during reception the ACK handshake packet is not
sent, during transmission a bit-stuffing error is
forced on the transmitted stream. In both cases
the host will retry the transaction. The DOVR inter-
rupt should never occur during normal operations.
Bit 5 = ERR: Error.
One of the errors listed below has occurred:
– NANS: No answer. The timeout for a host re-
– CRC: CRC error. One of the received CRCs, ei-
– BST: Bit Stuffing error. A bit stuffing error was
– FVIO: Framing format violation. A nonstandard
– BUFOVR: Buffer overrun. A packet longer than
sponse has expired.
ther in the token or in the data, was wrong.
detected anywhere in the PID, data, and/or CRC.
frame was received (EOP not in the right place,
wrong token sequence, etc.).
the allocated DMA buffer has been received.