ST92E163-EPB/US STMicroelectronics, ST92E163-EPB/US Datasheet - Page 96

• Manufacturer Part Number: ST92E163-EPB/US
• Description: KIT DEMO MASS STORAGE
• Manufacturer: STMicroelectronics
• Type: Microcontroller Programmerr

Specifications of ST92E163-EPB/US

• Contents: Programmer, Cable, Power Supply, Software, Manual and more
• For Use With/related Products: ST9 MCUs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST92163R4 - EXTERNAL MEMORY INTERFACE (EXTMI)
6.3 REGISTER DESCRIPTION
EXTERNAL MEMORY REGISTER 1 (EMR1)
R245 - Read/Write
Register Page: 21
Reset value: 1000 0000 (80h)
Bit 7 = Reserved.
Bit 6 = MC: Mode Control.
0: AS, DS and RW pins keep the ST9OLD mean-
1: AS pin becomes ALE, Address Load Enable
Bit 5 = DS2EN: Data Strobe 2 enable.
0: The DS2 pin is forced to “1” during the whole
1: If the lower memory block is addressed, the
Refer to
96/230
ing.
(AS inverted); Thus Memory Adress, Read/
Write signals are valid whenever a falling edge
of ALE occurs.
DS becomes OEN, Output ENable: it keeps the
ST9OLD meaning during external read opera-
tions, but is forced to “1” during external write
operations.
RW pin becomes WEN, Write ENable: it follows
the ST9OLD DS meaning during external write
operations, but is forced to “1” during external
read operations.
memory cycle.
DS2 pin follows the ST9OLD DS meaning (if
MC=0) or it becomes OEN (if MC=1). The DS
pin is forced to 1 during the whole memory cy-
cle.
If the upper memory block is used, DS2 is forced
to “1” during the whole memory cycle. The DS
pin behaviour is not modified.
7
x
MC
Figure 53
DS2EN ASAF
x
ETO
BSZ
X
0
Bit 4 = ASAF: Address Strobe as Alternate Func-
tion.
Depending on the device, AS can be either a ded-
icated pin or a port Alternate Function. This bit is
used only in this last case.
0: AS Alternate function disabled.
1: AS Alternate Function enabled.
Bit 2 = ETO: External toggle.
0: The external memory interface pins (AS, DS,
1: When the internal memory protection is dis-
Bit 1 = BSZ: Bus size.
0: All the I/O ports including the external memory
1: All the I/O ports including the external memory
Bit 0 = Reserved.
WARNING: External memory must be correctly
addressed before and after a write operation on
the EMR1 register. For example, if code is fetched
from external memory using the ST9OLD external
memory interface configuration (MC=0), setting
the MC bit will cause the device to behave unpre-
dictably.
DS2, RW, Port0, Port1) toggle only if an access
to external memory is performed.
abled (mask option available on some devices
only), the above pins (except DS and DS2 which
never toggle during internal memory accesses)
toggle during both internal and external memory
accesses.
interface pins use smaller, less noisy output
buffers. This may limit the operation frequency
of the device, unless the clock is slow enough or
sufficient wait states are inserted.
interface pins (AS, DS, DS2, R/W, Port 0, 1) use
larger, more noisy output buffers .