ST92E163-EPB/US STMicroelectronics, ST92E163-EPB/US Datasheet - Page 170

• Manufacturer Part Number: ST92E163-EPB/US
• Description: KIT DEMO MASS STORAGE
• Manufacturer: STMicroelectronics
• Type: Microcontroller Programmerr

Specifications of ST92E163-EPB/US

• Contents: Programmer, Cable, Power Supply, Software, Manual and more
• For Use With/related Products: ST9 MCUs
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

ST92163R4 - MULTIPROTOCOL SERIAL COMMUNICATIONS INTERFACE (SCI-M)
MULTIPROTOCOL SERIAL COMMUNICATIONS INTERFACE (Cont’d)
INTERRUPT MASK REGISTER (IMR)
R246 - Read/Write
Reset value: 0xx00000
Bit 7 = BSN: Buffer or shift register empty inter-
rupt.
This bit selects the source of the transmitter regis-
ter empty interrupt.
0: Select a Shift Register Empty as source of a
1: Select a Buffer Register Empty as source of a
Bit 6 = RXEOB: Received End of Block.
This bit is set by hardware only and must be reset
by software. RXEOB is set after a receiver DMA
cycle to mark the end of a data block.
0: Clear the interrupt request.
1: Mark the end of a received block of data.
Bit 5 = TXEOB: Transmitter End of Block.
This bit is set by hardware only and must be reset
by software. TXEOB is set after a transmitter DMA
cycle to mark the end of a data block.
0: Clear the interrupt request.
1: Mark the end of a transmitted block of data.
170/230
BSN
Transmitter Register Empty interrupt.
Transmitter Register Empty interrupt.
7
RXEOB TXEOB
RXE
RXA
RXB
RXDI
TXDI
0
Bit 4 = RXE: Receiver Error Mask.
0: Disable Receiver error interrupts (OE, PE, and
1: Enable Receiver error interrupts.
Bit 3 = RXA: Receiver Address Mask.
0: Disable Receiver Address interrupt (RXAP
1: Enable Receiver Address interrupt.
Bit 2 = RXB: Receiver Break Mask.
0: Disable Receiver Break interrupt (RXBP pend-
1: Enable Receiver Break interrupt.
Bit 1 = RXDI: Receiver Data Interrupt Mask.
0: Disable Receiver Data Pending and Receiver
1: Enable Receiver Data Pending and Receiver
Note: RXDI has no effect on DMA transfers.
Bit 0 = TXDI: Transmitter Data Interrupt Mask.
0: Disable Transmitter Buffer Register Empty,
1: Enable Transmitter Buffer Register Empty,
Note: TXDI has no effect on DMA transfers.
FE pending bits in the S_ISR register).
pending bit in the S_ISR register).
ing bit in the S_ISR register).
End of Block interrupts (RXDP and RXEOB
pending bits in the S_ISR register).
End of Block interrupts.
Transmitter Shift Register Empty, or Transmitter
End of Block interrupts (TXBEM, TXSEM, and
TXEOB bits in the S_ISR register).
Transmitter Shift Register Empty, or Transmitter
End of Block interrupts.