HD6417705F133BV Renesas Electronics America, HD6417705F133BV Datasheet - Page 331

• Manufacturer Part Number: HD6417705F133BV
• Description: MPU 3V 0K PB-FREE 208 FP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417705F133BV

• Core Processor: SH-3
• Core Size: 32-Bit
• Speed: 133MHz
• Connectivity: EBI/EMI, FIFO, IrDA, SCI, USB
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 105
• Program Memory Type: ROMless
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 1.4 V ~ 1.6 V
• Data Converters: A/D 4x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

9.6
When Using an External Crystal Resonator: Place the crystal resonator, capacitors CL1 and
CL2, and damping resistance R as close as possible to the EXTAL and XTAL pins. To prevent
induction from interfering with correct oscillation, use a common grounding point for the
capacitors connected to the resonator, and do not locate a wiring pattern near these components.
Decoupling Capacitors: As far as possible, insert a laminated ceramic capacitor of 0.1 to 1 µF as
a passive capacitor for each V
as possible to the chip’s power supply pins, and use components with a frequency characteristic
suitable for the chip’s operating frequency, as well as a suitable capacitance value.
Digital system V
80, 87-89, 111-113, 130-132, 133-138, 159-161, 178-180, 182-184, 199-204
On-chip oscillator V
When Using a PLL Oscillator Circuit: Keep the wiring from the PLL V
connection pattern to the power supply pins short, and make the pattern width wide, to minimize
the inductance value.
In clock mode 7, connect the EXTAL pin to V
the XTAL pin open.
Usage Notes
Figure 9.2 Points for Attention when Using Crystal Resonator
SS
/V
SS
SS
/V
Q and V
SS
Q and V
Note: The values for CL1, CL2, and damping resistance
SS
CC
/V
should be determined after consultation with the
crystal resonator manufacturer.
/V
SS
CC
Q and V
CC
/V
Q pairs: 2-5, 17-19, 26-28, 32-34, 44-46, 57-59, 69-71, 78-
EXTAL
Avoid crossing
signal lines
CC
Q pairs: 6-9, 149-150, 151-152, 205-208
CL1
CC
CC
/V
This LSI
Q (3.3-V power) with pull-up resistor, and leave
CC
CL2
Q pair. Mount the passive capacitors as close
XTAL
R
Rev. 2.00, 09/03, page 283 of 690
CC
and PLL V
SS