TDA5230 Infineon Technologies, TDA5230 Datasheet - Page 85

• Manufacturer Part Number: TDA5230
• Description: IC RECEIVER ASK/FSK 28-TSSOP
• Manufacturer: Infineon Technologies
• Type: Receiverr

Specifications of TDA5230

• Package / Case: 28-TSSOP
• Frequency: 433MHz ~ 450MHz, 865MHz ~ 868MHz
• Sensitivity: -111dBm
• Data Rate - Maximum: 20 kbps
• Modulation Or Protocol: ASK, FSK
• Applications: RKE, TPM, Security Systems
• Current - Receiving: 8mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Voltage - Supply: 3 V ~ 3.6 V, 4.5 V ~ 5.5 V
• Operating Temperature: -40°C ~ 105°C
• Operating Frequency: 870 MHz
• Operating Supply Voltage: 3.3 V, 5 V
• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Memory Size: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: SP000076520; TDA5230; TDA5230INTR

The next diagram shows the system characteristics to consider in choosing the best
Signal Detector level. On the one hand, achieving good FAR (False Alarm Rate)
performance that a higher threshold level must be set, but the MER/BER (Message Error
Rate/Bit Error Rate) performance (high SIGDET level signal) will decrease. On the other
hand, the MER/BER performance can be increased by setting smaller threshold levels
but then the FAR performance (low SIGDET level signal) will worsen.
Figure 42
Quick Procedure to Determine Signal and Noise Detector Thresholds:
Preparation
A set up is required with original RF hardware as in the final application. The values of
ASKNP and FSKNP can be read via the final application or using the TDA523x Explorer.
A complete configuration file using right modulation, data rate and Run Mode Slave,
must be prepared using the IAF TDA523x Configuration Tool and downloaded to the
TDA523x.
Signal Detector Threshold for ASK
Take 500 readings of ASKNP (50 are also possible, but this leads to less accurate
results) with no RF input signal applied (=noise only). Calculate average and Standard
Deviation (automatically done by TDA523x Explorer). Signal Detector Threshold is
average plus 2 times the standard deviation. To load the SIGDET register the calculated
value must be rounded and converted to hexadecimals. For a final application, the Signal
Detector Threshold should be varied to optimize the false alarm rate and the sensitivity.
Signal and Noise Detector Thresholds for FSK
Signal Detector Threshold
Data Sheet
signal power
high SDTHR level
low SDTHR level
input data
SDTHR level area
Signal Detection Threshold Level
performance
better FAR
81
telegram
optional bridged by
the sigdet counter
Functional Description
Version 4.0, 2007-06-01
performance
better MER
TDA523x