M95M02-DRMN6TP STMicroelectronics, M95M02-DRMN6TP Datasheet - Page 19

• Manufacturer Part Number: M95M02-DRMN6TP
• Description: IC EEPROM SPI BUS 2MB 8SOIC
• Manufacturer: STMicroelectronics
• Series: -r

Specifications of M95M02-DRMN6TP

• Mfg Application Notes: Make the Most of Serial EEPROMs AppNote
• Format - Memory: EEPROMs - Serial
• Memory Type: EEPROM
• Memory Size: 2M (256K x 8)
• Speed: 5MHz
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 8-SOIC (0.154", 3.90mm Width)
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-11405-2

M95M02-DR
6.4
Figure 9.
Write Status Register (WRSR)
The Write Status Register (WRSR) instruction allows new values to be written to the Status
Register. Before it can be accepted, a Write Enable (WREN) instruction must previously
have been executed. After the Write Enable (WREN) instruction has been decoded and
executed, the device sets the Write Enable Latch (WEL).
The Write Status Register (WRSR) instruction is entered by driving Chip Select (S) low,
followed by the instruction code and the data byte on Serial Data Input (D).
The instruction sequence is shown in
The Write Status Register (WRSR) instruction has no effect on b6, b5, b4, b1 and b0 of the
Status Register. b6, b5 and b4 are always read as 0.
Chip Select (S) must be driven high after the rising edge of Serial Clock (C) that latches in
the eighth bit of the data byte, and before the next rising edge of Serial Clock (C). Otherwise,
the Write Status Register (WRSR) instruction is not properly executed. As soon as Chip
Select (S) is driven high, the self-timed Write Status Register cycle (whose duration is t
initiated. While the Write Status Register cycle is in progress, the Status Register may still
be read to check the value of the Write In Progress (WIP) bit. The Write In Progress (WIP)
bit is 1 during the self-timed Write Status Register cycle, and is 0 when it is completed.
When the cycle is completed, the Write Enable Latch (WEL) is reset.
S
C
D
Q
Read Status Register (RDSR) sequence
0
High Impedance
1
2
Instruction
3
4
5
Doc ID 18203 Rev 4
6
7
MSB
7
8
Figure
6
Status Register Out
9 10 11 12 13 14 15
5
4
10.
3
2
1
0
MSB
7
6
Status Register Out
5
4
3
2
1
Instructions
0
7
AI02031E
W
19/40
) is