S29GL256P10FFI022 Spansion, S29GL256P10FFI022 Datasheet - Page 27

• Manufacturer Part Number: S29GL256P10FFI022
• Description: Flash 256M, 3V, 110ns Parallel NOR Flash
• Manufacturer: Spansion

Specifications of S29GL256P10FFI022

• Rohs: yes
• Data Bus Width: 16 bit
• Memory Type: NOR Flash
• Memory Size: 256 Mbit
• Architecture: Uniform
• Timing Type: Asynchronous
• Interface Type: CFI
• Access Time: 100 ns
• Supply Voltage - Max: 3.6 V
• Supply Voltage - Min: 2.7 V
• Maximum Operating Current: 110 mA
• Operating Temperature: - 40 C to + 85 C
• Mounting Style: SMD/SMT
• Package / Case: FBGA-64
• Organization: 128 KB x 1024

October 22, 2012 S29GL-P_00_A14
The write-buffer “embedded” programming operation can be suspended using the standard suspend/resume
commands. Upon successful completion of the Write Buffer Programming operation, the device returns to
READ mode.
The Write Buffer Programming Sequence is ABORTED under any of the following conditions:
 Load a value that is greater than the page buffer size during the “Number of Locations to Program” step.
 Write to an address in a sector different than the one specified during the Write-Buffer-Load command.
 Write an Address/Data pair to a different write-buffer-page than the one selected by the “Starting Address”
 Writing anything other than the Program to Buffer Flash Command after the specified number of “data
The ABORT condition is indicated by DQ1 = 1, DQ7 = DATA# (for the “last address location loaded”), DQ6 =
TOGGLE, DQ5 = 0. This indicates that the Write Buffer Programming Operation was ABORTED. A “Write-to-
Buffer-Abort reset” command sequence is required when using the write buffer Programming features in
Unlock Bypass mode. Note that the Secured Silicon sector, autoselect, and CFI functions are unavailable
when a program operation is in progress.
Write buffer programming is allowed in any sequence of memory (or address) locations. These flash devices
are capable of handling multiple write buffer programming operations on the same write buffer address range
without intervening erases.
Use of the write buffer is strongly recommended for programming when multiple words are to be
programmed.
during the “write buffer data loading” stage of the operation.
load” cycles.
D a t a
S29GL-P MirrorBit
S h e e t
®
Flash Family
27