S29GL256P10FFI022 Spansion, S29GL256P10FFI022 Datasheet - Page 41

• Manufacturer Part Number: S29GL256P10FFI022
• Description: Flash 256M, 3V, 110ns Parallel NOR Flash
• Manufacturer: Spansion

Specifications of S29GL256P10FFI022

• Rohs: yes
• Data Bus Width: 16 bit
• Memory Type: NOR Flash
• Memory Size: 256 Mbit
• Architecture: Uniform
• Timing Type: Asynchronous
• Interface Type: CFI
• Access Time: 100 ns
• Supply Voltage - Max: 3.6 V
• Supply Voltage - Min: 2.7 V
• Maximum Operating Current: 110 mA
• Operating Temperature: - 40 C to + 85 C
• Mounting Style: SMD/SMT
• Package / Case: FBGA-64
• Organization: 128 KB x 1024

October 22, 2012 S29GL-P_00_A14
7.9.3
Software Reset
Software reset is part of the command set (see
read mode and must be used for the following conditions:
Software Functions and Sample Code
Note
Base = Base Address.
The following is a C source code example of using the reset function. Refer to the Spansion Low Level Driver
User’s Guide (available on www.spansion.com) for general information on Spansion Flash memory software
development guidelines.
The following are additional points to consider when using the reset command:
 This command resets the sectors to the read and address bits are ignored.
 Reset commands are ignored during program and erase operations.
 The reset command may be written between the cycles in a program command sequence before
 If the program command sequence is written to a sector that is in the Erase Suspend mode, writing the
 The reset command may be written during an Autoselect command sequence.
 If a sector has entered the Autoselect mode while in the Erase Suspend mode, writing the reset command
 If DQ1 goes high during a Write Buffer Programming operation, the system must write the “Write to Buffer
 To exit the unlock bypass mode, the system must issue a two-cycle unlock bypass reset command
/* Example: Reset (software reset of Flash state machine) */
programming begins (prior to the third cycle). This resets the sector to which the system was writing to the
read mode.
reset command returns that sector to the erase-suspend-read mode.
returns that sector to the erase-suspend-read mode.
Abort Reset” command sequence to RESET the device to reading array data. The standard RESET
command does not work during this condition.
sequence [see Command Definitions
1. to exit Autoselect mode
2. when DQ5 goes high during write status operation that indicates program or erase cycle was not
3. exit sector lock/unlock operation.
4. to return to erase-suspend-read mode if the device was previously in Erase Suspend mode.
5. after any aborted operations
*( (UINT16 *)base_addr ) = 0x00F0;
successfully completed
Reset Command
Cycle
D a t a
S29GL-P MirrorBit
S h e e t
Operation
(LLD Function = lld_ResetCmd)
Write
on page 68
Table 7.18 Reset
®
Table 12.1 on page
Flash Family
for details].
Byte Address
Base + xxxh
69) that also returns the device to array
Word Address
Base + xxxh
00F0h
Data
41