DF2378BVFQ35WV Renesas Electronics America, DF2378BVFQ35WV Datasheet - Page 471

• Manufacturer Part Number: DF2378BVFQ35WV
• Description: IC H8S/2378 MCU FLASH 144-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2378BVFQ35WV

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 35MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 97
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 6x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-QFP
• For Use With: EDK2378 - DEV EVAL KIT FOR H8S/2378
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

EDREQ Pin Falling Edge Activation Timing: Figure 8.26 shows an example of single address
mode transfer activated by the EDREQ pin falling edge.
EDREQ pin sampling is performed in each cycle starting at the next rise of φ after the end of the
EDMDR write cycle for setting the transfer-enabled state.
When a low level is sampled at the EDREQ pin while acceptance via the EDREQ pin is possible,
the request is held within the EXDMAC. Then when activation is initiated within the EXDMAC,
the request is cleared, and EDREQ pin high level sampling for edge sensing is started. If EDREQ
pin high level sampling is completed by the end of the DMA single cycle, acceptance resumes
after the end of the single cycle, and EDREQ pin low level sampling is performed again; this
sequence of operations is repeated until the end of the transfer.
[1]
[2], [5] Request is cleared at end of next bus cycle, and activation is started in EXDMAC.
[3], [6] DMA cycle start; EDREQ pin high level sampling is started at rise of φ.
[4], [7] When EDREQ pin high level has been sampled, acceptance is resumed after completion of single cycle.
Figure 8.26 Example of Single Address Mode Transfer Activated by EDREQ Pin Falling
Acceptance after transfer enabling; EDREQ pin low level is sampled at rise of φ, and request is held.
(As in [1], EDREQ pin low level is sampled at rise of φ, and request is held.)
φ
EDREQ
Address bus
EDACK
DMA control
Channel
Idle
[1]
Minimum 3 cycles
Request
Bus release
[2]
clearance period
Single
[3]
Request
DMA single
Transfer source/
destination
Edge
Idle
Acceptance
resumed
[4]
Minimum 3 cycles
Request
Bus release
Rev.7.00 Mar. 18, 2009 page 403 of 1136
Section 8 EXDMA Controller (EXDMAC)
[5]
clearance period
Single
[6]
Request
Transfer source/
DMA single Bus release
destination
Idle
Acceptance
resumed
[7]
REJ09B0109-0700