HD6417708SF60V Renesas Electronics America, HD6417708SF60V Datasheet - Page 252

• Manufacturer Part Number: HD6417708SF60V
• Description: IC SUPERH MPU ROMLESS 208LQFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7700r

Specifications of HD6417708SF60V

• Core Processor: SH-2
• Core Size: 32-Bit
• Speed: 60MHz
• Connectivity: EBI/EMI, SCI, SmartCard
• Peripherals: POR, WDT
• Number Of I /o: 8
• Program Memory Type: ROMless
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Ram Size: -
• Program Memory Size: -
• Data Converters: -

The number of bus cycles is selected between 0 and 10 wait cycles using the A6W2–A6W0 bits in
WCR2. Also, any number of waits can be inserted in each bus cycle by means of the external wait
pin (WAIT). When the burst function is used, the bus cycle pitch of the burst cycle is determined
within a range of 2–10 according to the number of waits. The setup and hold times of
address/CE1B/CE2B for the read/write strobe signals can be set within a range of 0.5–3.5 cycles
using A6TED1–A6TED0 and A6TEH1–A6TEH0.
If PCMCIA is used in area 6, synchronous DRAM is used at the same time, and a synchronous
DRAM auto-refresh (CAS-before-RAS refresh) request is issued simultaneously, area 6 card
enable signals CS6 and CE2B may be asserted earlier than usual, at the same time as the
immediately preceding auto-refresh cycle. When both PCMCIA and synchronous DRAM are
used, they should be used in area 5. When area 5 is used, the system design should provide for CS
to be asserted early without causing any problems.
10.3.3
Basic Interface
Basic Timing: The basic interface of the SH7708 Series uses strobe signal output because mainly
SRAM will be directly connected. Figure 10.6 shows the basic timing of normal space accesses. A
no-wait normal access is completed in two cycles. The BS signal is asserted for one cycle to
indicate the start of a bus cycle. The CSn signal is negated on the T2 clock falling edge to secure
the negation period. Therefore, at minimum pitch, there is a half-cycle negation period.
There is no access size specification when reading. The correct access start address is output in the
least significant bit of the address, but since there is no access size specification, 32 bits are always
read in a 32-bit device, and 16 bits in a 16-bit device. When writing, only the WE signal for the
byte to be written is asserted. For details, see section 10.3.1, Endian/Access Size and Data
Alignment.
Read/write for cache fill or copy-back follows the set bus width and transfers a total of 16 bytes
continuously. The bus is not released during this transfer. For cache misses that occur during byte
or word operand accesses or branching to odd word boundaries, the fill is always performed by
longword accesses on the chip-external interface. Write-through area write access and
noncacheable read/write access is based on the actual address size.
232