R5F21334CNFP#U0 Renesas Electronics America, R5F21334CNFP#U0 Datasheet - Page 373

• Manufacturer Part Number: R5F21334CNFP#U0
• Description: MCU 1KB FLASH 16K ROM 32-LQFP
• Manufacturer: Renesas Electronics America
• Series: R8C/3x/33Cr

Specifications of R5F21334CNFP#U0

• Core Processor: R8C
• Core Size: 16/32-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SIO, SSU, UART/USART
• Peripherals: POR, PWM, Voltage Detect, WDT
• Number Of I /o: 27
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 1.5K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 32-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

R8C/33C Group
REJ09B0570-0100 Rev.1.00 Dec. 14, 2009
Page 343 of 589
Figure 22.6
22.3.5
22.3.6
If the U2LCH bit in the U2C1 register is set to 1 (inverted), the data written to the U2TB register has its logic
inverted before being transmitted. Similarly, the received data has its logic inverted when read from the U2RB
register. Figure 22.6 shows the Serial Data Logic Switching.
The CTS function is used to start transmit and receive operation when “L” is applied to the CTS2/RTS2 pin.
Transmit and receive operation begins when the CTS2/RTS2 pin is held low. If the “L” signal is switched to
“H” during a transmit or receive operation, the operation stops before the next data.
For the RTS function, the CTS2/RTS2 pin outputs “L” when the MCU is ready for a receive operation. The
output level goes high at the first falling edge of the CLK2 pin.
• The CRD bit in the U2C0 register = 1 (CTS/RTS function disabled)
• The CRD bit = 0, CRS bit = 0 (CTS function selected)
• The CRD bit = 0, CRS bit = 1 (RTS function selected)
The CTS2/RTS2 pin operates as the programmable I/O function.
The CTS2/RTS2 pin operates as the CTS function.
The CTS2/RTS2 pin operates as the RTS function.
Serial Data Logic Switching Function
CTS/RTS Function
(1) U2LCH Bit in U2C1 Register = 0 (not inverted)
(2) U2LCH Bit in U2C1 Register = 1 (inverted)
The above applies when:
Serial Data Logic Switching
• CKPOL bit in U2C0 register = 0 (transmit data output at the falling edge of the transfer clock)
• UFORM bit in U2C0 register = 0 (LSB first)
Transfer Clock
Transfer Clock
(not inverted)
(inverted)
TXD2
TXD2
D0
D0
D1
D1
D2
D2
D3
D3
D4
D4
D5
D5
D6
D6
D7
D7
22. Serial Interface (UART2)