UPD70F3735GK-GAK-AX Renesas Electronics America, UPD70F3735GK-GAK-AX Datasheet - Page 274

• Manufacturer Part Number: UPD70F3735GK-GAK-AX
• Description: MCU 32BIT V850ES/JX3-L 80-LQFP
• Manufacturer: Renesas Electronics America
• Series: V850ES/Jx3-Lr

Specifications of UPD70F3735GK-GAK-AX

• Core Processor: RISC
• Core Size: 32-Bit
• Speed: 20MHz
• Connectivity: CSI, EBI/EMI, I²C, UART/USART
• Peripherals: DMA, LVD, PWM, WDT
• Number Of I /o: 66
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 2.2 V ~ 3.6 V
• Data Converters: A/D 8x10b, D/A 1x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

V850ES/JF3-L
7.6
alternate-function pin (TIP10/TIP11) and the peripheral I/O (TMP/UARTA) input signal via the UARTA reception alternate-
function pin (RXDA0/RXDA1).
R01UH0017EJ0400 Rev.4.00
Sep 30, 2010
In the V850ES/JF3-L, the capture trigger input for TMP1 can be selected from the input signal via the port/timer
By using this function, the following is possible.
• The TIP10 and TIP11 input signals of TMP1 can be selected from the port/timer alternate-function pins (TIP10 and
The capture input for the selector function is specified by the following register.
(1) Selector operation control register 0 (SELCNT0)
TIP11 pins) and the UARTA reception alternate-function pins (RXDA0 and RXDA1).
→ When the RXDA0 or RXDA1 signal of UART0 or UART1 is selected, the LIN reception transfer rate and baud rate
Cautions 1. When using the selector function, set the capture trigger input of TMP before connecting the
Selector Function
The SELCNT0 register is an 8-bit register that selects the capture trigger for TMP1.
This register can be read or written in 8-bit or 1-bit units.
Reset sets this register to 00H.
error of UARTA can be calculated.
2. When setting the selector function, first disable the peripheral I/O to be connected (TMP or
SELCNT0
timer.
UARTA).
After reset:
Cautions 1. To set ISEL3 and ISEL4 bits to 1, set the corresponding pin in the
ISEL4
ISEL3
00H
0
1
0
1
0
2. Be sure to clear bits 7 to 5 and 2 to 1 to “0”.
TIP11 pin input
RXDA1 pin input
TIP10 pin input
RXDA0 pin input
R/W
capture input mode.
0
Address:
0
Selection of TIP11 input signal (TMP1)
Selection of TIP10 input signal (TMP1)
CHAPTER 7 16-BIT TIMER/EVENT COUNTER P (TMP)
FFFFF308H
ISEL4
< >
ISEL3
< >
0
0
0
Page 258 of 816