ST72361AR9-Auto STMicroelectronics, ST72361AR9-Auto Datasheet - Page 164

• Manufacturer Part Number: ST72361AR9-Auto
• Description: 8-bit MCU for automotive with K Flash, 10-bit ADC, 5 Timers, SPI, 2x LINSCI
• Manufacturer: STMicroelectronics

Specifications of ST72361AR9-Auto

• Hdflash Endurance: 100 cycles, data retention 20 years at 55 °C
• 5 Power Saving Modes: halt, auto wake up from halt, active halt, wait and slow

LINSCI serial communication interface (LIN master/slave)
15.5.7
164/279
Figure 79. SCI baud rate and extended prescaler block diagram
Receiver muting and wake-up feature
In multiprocessor configurations it is often desirable that only the intended message
recipient should actively receive the full message contents, thus reducing redundant SCI
service overhead for all non-addressed receivers.
The non-addressed devices may be placed in sleep mode by means of the muting function.
Setting the RWU bit by software puts the SCI in sleep mode:
All the reception status bits can not be set.
All the receive interrupts are inhibited.
A muted receiver may be woken up in one of the following ways:
●
●
by Idle Line detection if the WAKE bit is reset,
by Address Mark detection if the WAKE bit is set.
f
CPU
/16
/PR
EXTENDED TRANSMITTER PRESCALER REGISTER
EXTENDED RECEIVER PRESCALER REGISTER
EXTENDED PRESCALER TRANSMITTER RATE CONTROL
EXTENDED PRESCALER RECEIVER RATE CONTROL
SCP1
CONVENTIONAL BAUD RATE GENERATOR
Doc ID 12468 Rev 3
SCP0 SCT2 SCT1 SCT0 SCR2 SCR1SCR0
TRANSMITTER RATE
EXTENDED PRESCALER
CONTROL
RECEIVER RATE
CONTROL
SCIBRR
SCIERPR
SCIETPR
ST72361xx-Auto
RECEIVER
TRANSMITTER
CLOCK
CLOCK