ST72361AR9-Auto STMicroelectronics, ST72361AR9-Auto Datasheet - Page 227

• Manufacturer Part Number: ST72361AR9-Auto
• Description: 8-bit MCU for automotive with K Flash, 10-bit ADC, 5 Timers, SPI, 2x LINSCI
• Manufacturer: STMicroelectronics

Specifications of ST72361AR9-Auto

• Hdflash Endurance: 100 cycles, data retention 20 years at 55 °C
• 5 Power Saving Modes: halt, auto wake up from halt, active halt, wait and slow

ST72361xx-Auto
19
19.1
19.1.1
19.1.2
19.1.3
19.1.4
19.1.5
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3).
Typical values
Unless otherwise specified, typical data is based on T
4.5V  V
tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean±2)
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in
Figure 95. Pin loading conditions
Pin input voltage
The input voltage measurement on a pin of the device is described in
DD
 5.5V voltage range). They are given only as design guidelines and are not
C
Doc ID 12468 Rev 3
L
ST7 PIN
A
A
= 25°C, V
= 25°C and T
SS
.
.
Electrical characteristics
DD
= 5V (for the
A
Figure
= T
A
Figure
max (given by
119.
118.
227/279