TMPM364F10FG Toshiba, TMPM364F10FG Datasheet - Page 233

• Manufacturer Part Number: TMPM364F10FG
• Manufacturer: Toshiba

Specifications of TMPM364F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 144
• Package: LQFP(20x20)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 5
• Uart/sio (ch): 12
• Usb: Host
• Can: 1
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 16
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

8.2.15
Type
8.2.15.1
8.2.15.2
in units of bits. Besides the general-purpose input / output function, the port O performs the serial interface func-
tion(UART/SIO), External signal interrupt input and 16bit timer output function.
to the corresponding bit of the three registers. If you use the port O as other than a general-purpose port, set
"1" to the corresponding bit of the function register. Do not set "1" to the some function registers at the same
time.
input in the POIE register. These settings enable the interrupt input even if the CGSTBYCR<DRVE> bit in
the clock / mode control block is set to stop driving of pins during STOP mode.
Port O data register
Port O output control register
Port O function register 1
Port O function register 2
Port O function register 3
Port O open drain control registert
Port O pull-up control register
Port O input control register
The port O is a general-purpose, 8-bit input / output port. For this port, inputs and outputs can be specified
Reset initializes all bits of the port O as general-purpose ports with input, output and pull-up disabled.
The Port O has three types of of function register. If you use the port O as a general-purpose port, set "0"
To use the external interrupt input for releasing STOP mode, select this function in the POFR1 and enable
Port O (PO0 to PO7)
Note:In modes other than STOP mode, interrupt input is enabled regardless of the POFR1 register setting
Port O Circuit Type
Port O register
if input is enabled in PxIE. Make sure to disable unused interrupts when programming the device.
T21
7
T24
6
Register name
T23
5
Page 207
T22
4
PODATA
POPUP
POFR1
POFR2
POFR3
POCR
POOD
POIE
T21
3
T24
Base Address = 0x400C_0E00
2
Address (Base+)
0x000C
0x002C
0x0000
0x0004
0x0008
0x0010
0x0028
0x0038
T23
1
TMPM364F10FG
T22
0