TMPM364F10FG Toshiba, TMPM364F10FG Datasheet - Page 659

• Manufacturer Part Number: TMPM364F10FG
• Manufacturer: Toshiba

Specifications of TMPM364F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 144
• Package: LQFP(20x20)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 5
• Uart/sio (ch): 12
• Usb: Host
• Can: 1
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 16
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

1
0
Bit
PES
CCS
Bit Symbol
R/W
R/W
(HCD)
Type
R/W
R/W
Type
(HC)
(read)Port Enable Status
This bit indicates whether the port is enabled or disabled. The Root Hub may clear this bit when
an overcurrent condition, disconnect event, switched-off power, or operational bus error such as
babble is detected. This change also causes PortEnabledStatusChange to be set. HCD sets this
bit by writing SetPortEnable and clears it by writing ClearPortEnable. This bit cannot be set when
CurrentConnectStatus is cleared. This bit is also set, if not already, at the completion of a port re-
set when ResetStatusChange is set or port suspend when SuspendStatusChange is set.
0: Port is disabled.
1: Port is enabled.
(write)Set Port Enable
The HCD sets PortEnableStatus by writing a "1". Writing a "0" has no effect. If CurrentConnectSta-
tus is cleared, this write does not set PortEnableStatus, but instead sets ConnectStatusChange.
This informs the driver that it attempted to enable a disconnected port.
(read)Current Connect Status
This bit reflects the current state of the downstream port.
0: No device connected
1: Device connected
(write)Clear Port Enable
The HCD writes a "1" to this bit to clear the PortEnableStatus bit. Writing a "0" has no effect. The
CurrentConnectStatus is not affected by any write.
(Note)
This bit is always read as '1' when the attached device is nonremovable (DeviceRemoveable[NDP]).
Page 633
Function
TMPM364F10FG