mt48h16m32lfcm-75-it Micron Semiconductor Products, mt48h16m32lfcm-75-it Datasheet - Page 32
mt48h16m32lfcm-75-it
Manufacturer Part Number
mt48h16m32lfcm-75-it
Description
512mb 32 Meg X 16, 16 Meg X 32 Mobile Sdram Features
Manufacturer
Micron Semiconductor Products
Datasheet
1.MT48H16M32LFCM-75-IT.pdf
(75 pages)
- Current page: 32 of 75
- Download datasheet (2Mb)
PDF: 09005aef82ea3742/Source: 09005aef82ea3752
sdr_mobile_sdram_cmd_op_timing_dia_fr4.08__4.fm - Rev. B 4/08 EN
10. READs or WRITEs listed in the Command (Action) column include READs or WRITEs with
11. Does not affect the state of the bank and acts as a NOP to that bank.
5. The following states must not be interrupted by any executable command; COMMAND
6. All states and sequences not shown are illegal or reserved.
7. Not bank-specific; requires that all banks are idle.
8. May or may not be bank specific; if all banks are to be precharged, all must be in a valid
9. This command is BURST TERMINATE when CKE is HIGH and DEEP POWER-DOWN when CKE
INHIBIT or NOP commands must be applied on each positive clock edge during these states.
Refreshing:
Accessing mode
register:
Precharging all:
state for precharging.
is LOW.
auto precharge enabled and READs or WRITEs with auto precharge disabled.
Read w/auto-
precharge enabled:
Write w/auto-
precharge enabled:
Starts with registration of a PRECHARGE ALL command and ends
Starts with registration of an AUTO REFRESH command and ends
when
banks idle state.
Starts with registration of a LOAD MODE REGISTER command and
ends when
SDRAM will be in the all banks idle state.
when
Starts with registration of a READ command with auto precharge
enabled and ends when
will be in the idle state.
Starts with registration of a WRITE command with auto precharge
enabled and ends when
will be in the idle state.
32
t
t
RFC is met. After
RP is met. After
t
MRD has been met. After
Micron Technology, Inc., reserves the right to change products or specifications without notice.
t
RP is met, all banks will be in the idle state.
t
t
t
RP has been met. After
RFC is met, the SDRAM will be in the all
RP has been met. After
t
MRD is met, the Mobile
©2007 Micron Technology, Inc. All rights reserved.
SDR Mobile SDRAM
t
t
RP is met, the bank
RP is met, the bank
Operations
Related parts for mt48h16m32lfcm-75-it
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
VFBGA 63/I°//MICRON NAND FLASH 1Gb Mass Storage
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
SYNCHRONOUS DRAM
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
Q-FLASHTM MEMORY
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
4Meg x 4, 3,3V FPM DRAM
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
4Meg x 4, 3,3V FPM DRAM
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
4Meg x 4 banks, EDO DRAM, 3.3V, standard refresh, 50ns
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
4Meg x 4 banks, EDO DRAM, 3.3V, standard refresh, 50ns
Manufacturer:
Micron Semiconductor Products
Datasheet:
Part Number:
Description:
4Meg x 4 banks, EDO DRAM, 3.3V, standard refresh, 60ns
Manufacturer:
Micron Semiconductor Products
Datasheet: