mt47h64m16hw-3 Micron Semiconductor Products, mt47h64m16hw-3 Datasheet - Page 71

• Manufacturer Part Number: mt47h64m16hw-3
• Description: 1gb X4, X8, X16 Ddr2 Sdram
• Manufacturer: Micron Semiconductor Products

LOAD MODE (LM)
ACTIVATE
READ
WRITE
PRECHARGE
PDF: 09005aef8117c187/Source: 09005aef821aed36
DDR2_x4x8x16_Core2.fm - 1Gb DDR2: Rev. N; Core DDR2: Rev. C 4/08 EN
The mode registers are loaded via bank address and address inputs. The bank address
balls determine which mode register will be programmed. See “Mode Register (MR)” on
page 76. The LM command can only be issued when all banks are idle, and a subsequent
executable command cannot be issued until
The ACTIVATE command is used to open (or activate) a row in a particular bank for a
subsequent access. The value on the bank address inputs determines the bank, and the
address inputs select the row. This row remains active (or open) for accesses until a
PRECHARGE command is issued to that bank. A PRECHARGE command must be issued
before opening a different row in the same bank.
The READ command is used to initiate a burst read access to an active row. The value on
the bank address inputs determine the bank, and the address provided on address
inputs A0–Ai (where Ai is the most significant column address bit for a given configura-
tion) selects the starting column location. The value on input A10 determines whether
or not auto precharge is used. If auto precharge is selected, the row being accessed will
be precharged at the end of the READ burst; if auto precharge is not selected, the row will
remain open for subsequent accesses.
DDR2 SDRAM also supports the AL feature, which allows a READ or WRITE command to
be issued prior to
command to the internal device by AL clock cycles.
The WRITE command is used to initiate a burst write access to an active row. The value
on the bank select inputs selects the bank, and the address provided on inputs A0–Ai
(where Ai is the most significant column address bit for a given configuration) selects the
starting column location. The value on input A10 determines whether or not auto
precharge is used. If auto precharge is selected, the row being accessed will be
precharged at the end of the WRITE burst; if auto precharge is not selected, the row will
remain open for subsequent accesses.
DDR2 SDRAM also supports the AL feature, which allows a READ or WRITE command to
be issued prior to
command to the internal device by AL clock cycles.
Input data appearing on the DQ is written to the memory array subject to the DM input
logic level appearing coincident with the data. If a given DM signal is registered LOW, the
corresponding data will be written to memory; if the DM signal is registered HIGH, the
corresponding data inputs will be ignored, and a WRITE will not be executed to that
byte/column location (see Figure 67 on page 106).
The PRECHARGE command is used to deactivate the open row in a particular bank or
the open row in all banks. The bank(s) will be available for a subsequent row activation a
specified time (
concurrent auto precharge, where a READ or WRITE command to a different bank is
allowed as long as it does not interrupt the data transfer in the current bank and does
t
RP) after the PRECHARGE command is issued, except in the case of
t
t
RCD (MIN) by delaying the actual registration of the READ/WRITE
RCD (MIN) by delaying the actual registration of the READ/WRITE
71
Micron Technology, Inc., reserves the right to change products or specifications without notice.
t
MRD is met.
1Gb: x4, x8, x16 DDR2 SDRAM
©2003 Micron Technology, Inc. All rights reserved.
Commands