AGL015 MICROSEMI [Microsemi Corporation], AGL015 Datasheet - Page 94

• Manufacturer Part Number: AGL015
• Description: IGLOO Low Power Flash FPGAs with Flash*Freeze Technology
• Manufacturer: MICROSEMI [Microsemi Corporation]

IGLOO DC and Switching Characteristics
Table 2-139 • Minimum and Maximum DC Input and Output Levels for LVCMOS 1.2 V Wide Range
Table 2-140 • 1.2 V LVCMOS Wide Range AC Waveforms, Measuring Points, and Capacitive Loads
2- 78
1.2 V LVCMOS
Wide Range
Drive
Strength
100 µA
Notes:
1. The minimum drive strength for the default LVCMOS 1.2 V software configuration when run in wide range is ± 100 µA.
2. IIL is the input leakage current per I/O pin over recommended operation conditions where –0.3 V < VIN < VIL.
3. IIH is the input leakage current per I/O pin over recommended operating conditions VIH < VIN < VCCI. Input current is
4. Currents are measured at 100°C junction temperature and maximum voltage.
5. Currents are measured at 85°C junction temperature.
6. Software default selection highlighted in gray.
Input Low (V)
0
*
Measuring point = Vtrip. See
The drive strength displayed in software is supported in normal range only. For a detailed I/V curve, refer to the IBIS
models.
larger when operating outside recommended ranges
Equivalent
Software
Strength
Option
Default
Drive
1 mA
Timing Characteristics
Refer to LVCMOS 1.2 V (normal range)
Applicable to Standard I/O Banks
1
Min.
–0.3 0.35 * VCCI 0.65 * VCCI 3.6 0.25 * VCCI 0.75 * VCCI 100 100 TBD TBD
V
VIL
Max.
Table 2-29 on page 2-28
V
Input High (V)
1.2
Min.
V
VIH
"Timing Characteristics" on page 2-76
Max.
V
for a complete table of trip points.
R ev i sio n 1 9
Measuring Point* (V)
Max.
VOL
V
0.6
VOH
Min.
V
IOL IOH IOSL IOSH IIL
mA mA
for worst-case timing.
Max.
mA
C
LOAD
4
Max.
mA
5
(pF)
4
µA
10
2
5
IIH
µA
10
3
5