C8051F530-TB Silicon Laboratories Inc, C8051F530-TB Datasheet - Page 67

• Manufacturer Part Number: C8051F530-TB
• Description: BOARD PROTOTYPE W/C8051F530
• Manufacturer: Silicon Laboratories Inc
• Type: MCUr

Specifications of C8051F530-TB

• Contents: Board
• Processor To Be Evaluated: C8051F52xA and C8051F53xA
• Interface Type: USB
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined
• For Use With/related Products: C8051F530
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

SFR Definition 4.8. ADC0CN: ADC0 Control
Bit7:
Bit6:
Bit5:
Bit4:
Bit3:
Bit2:
Bits1–0: AD0CM1–0: ADC0 Start of Conversion Mode Select.
AD0EN BURSTEN AD0INT AD0BUSY AD0WINT AD0LJST AD0CM1 AD0CM0 00000000
R/W
Bit7
AD0EN: ADC0 Enable Bit.
0: ADC0 Disabled. ADC0 is in low-power shutdown.
1: ADC0 Enabled. ADC0 is active and ready for data conversions.
BURSTEN: ADC0 Burst Mode Enable Bit.
0: ADC0 Burst Mode Disabled.
1: ADC0 Burst Mode Enabled.
AD0INT: ADC0 Conversion Complete Interrupt Flag.
0: ADC0 has not completed a data conversion since the last time AD0INT was cleared.
1: ADC0 has completed a data conversion.
AD0BUSY: ADC0 Busy Bit.
Read:
0: ADC0 conversion is complete or a conversion is not currently in progress. AD0INT is set
to logic 1 on the falling edge of AD0BUSY.
1: ADC0 conversion is in progress.
Write:
0: No Effect.
1: Initiates ADC0 Conversion if AD0CM1–0 = 00b
AD0WINT: ADC0 Window Compare Interrupt Flag.
This bit must be cleared by software.
0: ADC0 Window Comparison Data match has not occurred since this flag was last cleared.
1: ADC0 Window Comparison Data match has occurred.
AD0LJST: ADC0 Left Justify Select
0: Data in ADC0H:ADC0L registers is right justified.
1: Data in ADC0H:ADC0L registers is left justified. This option should not be used with a
repeat count greater than 1 (when AD0RPT1–0 is 01b, 10b, or 11b).
00: ADC0 conversion initiated on every write of 1 to AD0BUSY.
01: ADC0 conversion initiated on overflow of Timer 1.
10: ADC0 conversion initiated on rising edge of external CNVSTR.
11: ADC0 conversion initiated on overflow of Timer 2.
R/W
Bit6
R/W
Bit5
R/W
Bit4
C8051F52x/F52xA/F53x/F53xA
Rev. 1.3
R/W
Bit3
R/W
Bit2
R/W
Bit1
(bit addressable)
R/W
Bit0
SFR Address:
Reset Value
0xE8
67