IMU-3000 INVENSENSE, IMU-3000 Datasheet - Page 22

• Manufacturer Part Number: IMU-3000
• Description: GYRO, TRI-AXIS, PROG +/-2000 DEG/S
• Manufacturer: INVENSENSE

Specifications of IMU-3000

• No. Of Axes: 3
• Sensor Case Style: QFN
• No. Of Pins: 24
• Supply Voltage Range: 2.1V To 3.6V
• Operating Temperature Range: -40°C To +85°C
• Interface: I2C, Serial
• Interface Type: I2C, Serial
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Data Format / Acknowledge
I
data transfer. Each byte transferred must be followed by an acknowledge (ACK) signal. The clock for the
acknowledge signal is generated by the master, while the receiver generates the actual acknowledge signal
by pulling down SDA and holding it low during the HIGH portion of the acknowledge clock pulse.
If a slave is busy and cannot transmit or receive another byte of data until some other task has been
performed, it can hold SCL LOW, thus forcing the master into a wait state. Normal data transfer resumes
when the slave is ready, and releases the clock line (refer to the following figure).
Communications
After beginning communications with the START condition (S), the master sends a 7-bit slave address
followed by an 8
or is writing to the slave device. Then, the master releases the SDA line and waits for the acknowledge
signal (ACK) from the slave device. Each byte transferred must be followed by an acknowledge bit. To
acknowledge, the slave device pulls the SDA line LOW and keeps it LOW for the high period of the SCL line.
Data transmission is always terminated by the master with a STOP condition (P), thus freeing the
communications line. However, the master can generate a repeated START condition (Sr), and address
another slave without first generating a STOP condition (P). A LOW to HIGH transition on the SDA line while
SCL is HIGH defines the stop condition. All SDA changes should take place when SCL is low, with the
exception of start and stop conditions.
2
C data bytes are defined to be 8 bits long. There is no restriction to the number of bytes transmitted per
th
bit, the read/write bit. The read/write bit indicates whether the master is receiving data from
IMU-3000 Product Specification
Acknowledge on the I
Complete I
22 of 56
2
C Data Transfer
2
C Bus
Document Number: PS-IMU-3000A-00-01.1
Revision: 1.1
Release Date: 08/19/2010