82.031.0101.0 WIELAND ELECTRIC, 82.031.0101.0 Datasheet - Page 824

• Manufacturer Part Number: 82.031.0101.0
• Description: COUPLING MODULE
• Manufacturer: WIELAND ELECTRIC

Specifications of 82.031.0101.0

• Connector Type: Modular
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

facts
facts
Tables, technical data, explanations
Table 3:
Degree of protection against water, identified by the second identification number
The second identification number gives the protection category through housing in light of damaging influences
on the electrical equipment following penetration of water.
Table 3 gives short descriptions and definitions for the degrees of protection that are represented by the second
identification number .
Degrees of protection that are given in this table may only be determined by the second identification number
and not by reference to the short description or definition. Until the second identification number 6, the
designation means that the requirements for all the lower identification numbers have been fulfilled.
A housing that is identified only with the second identification number 7 or 8 is considered unsuitable for stress
through jet water (identified with the second identification number 5 or 6) and does not need to meet the
requirements of number 5 or 6. It should be provided with a double identification according to the following table:
822
822
Second identification
number
0
0
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
Degree of protection against water, identified by the second identification number
Brief description
unprotected
protected against dripping water
protected against dripping water if the housing
is sloped up to 15°
protected against spraying water
protected against splashing water
protected against jet water
protected against powerful jet water
protected against the effects of temporary
immersion in water
protected against the effects of continuous
immersion in water
& DATA
Degree of protection
Definition
–
Dripping water falling vertically must not have a damaging effect
Dripping water falling vertically must not have a damaging effect
if the housing is sloped by an angle of up to 15° both
sides of the vertical
Water that is sprayed at an angle of 60° both sides of the
vertical must not have any damaging effect
Water that is sprayed from all directions against the
housing must not have any damaging effect
Water that is directed from all directions as a jet against the
housing must not have any damaging effect
Water that is directed from all directions as a powerful jet
against the housing must not have any damaging effect
Water must not penetrate in a quantity to cause damage
if the housing is immersed temporarily in water under standard
pressure and time conditions
Water must not penetrate in a quantity to cause damage
if the housing is continuously immersed in water conditions
that must be arranged between the manufacturer and the
user. The conditions must however be more severe than for
identification number 7.