ISP1507BBS,118 NXP Semiconductors, ISP1507BBS,118 Datasheet - Page 44

• Manufacturer Part Number: ISP1507BBS,118
• Description: RF Transceiver USB 2.0 ULPI TRNSCVR
• Manufacturer: NXP Semiconductors

Specifications of ISP1507BBS,118

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Power Supply Requirement: Single
• Operating Supply Voltage (typ): 3.3V
• Operating Temperature Classification: Industrial
• Operating Supply Voltage (max): 3.6V
• Operating Supply Voltage (min): 3V
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Pin Count: 32
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Lead Free Status / RoHS Status: Compliant
• Other names: 935285495118 ISP1507BBS-T

NXP Semiconductors
ISP1507A_ISP1507B_1
Product data sheet
Fig 21. Transmitting USB packets without automatic SYNC and EOP generation
TXREADY
TXVALID
ENABLE
CLOCK
DP, DM
9.12 On-The-Go operations
STUFF
TXBIT
DATA
[7:0]
STP
NXT
DIR
PHY will not transmit any EOP. The ISP1507 will also detect if the PID byte is A5h,
indicating an SOF packet, and automatically send a long EOP when STP is asserted. To
transmit chirp and resume signaling, the link must set OPMODE to 10b.
On-The-Go (OTG) is a supplement to Universal Serial Bus Specification Rev. 2.0 that
allows a portable USB device to assume the role of a limited USB host by defining
improvements, such as a small connector and low power. Non-portable devices, such as
standard hosts and embedded hosts, can also benefit from OTG features.
The ISP1507 OTG PHY is designed to support all the tasks specified in the OTG
supplement. The ISP1507 provides the front-end analog support for Host Negotiation
Protocol (HNP) and Session Request Protocol (SRP) for dual-role devices. The
supporting components include:
The following subsections describe how to use the ISP1507 OTG components.
•
•
•
•
•
Built-in 5 V charge pump
Voltage comparators
– A_VBUS_VLD
– SESS_VLD (session valid, can be used for both A-session and B-session valid)
– SESS_END (session end)
Pull-up and pull-down resistors on DP and DM
ID detector indicates if micro-A or micro-B plug is inserted
Charge and discharge resistors on V
TXCMD
IDLE
00h
00h 00h 80h PID
SYNC
Rev. 01 — 19 May 2008
PID
D1
D2
BUS
D3
DATA PAYLOAD
ISP1507A; ISP1507B
...
... D
N
ULPI HS USB OTG transceiver
1
D
N
FEh
EOP
© NXP B.V. 2008. All rights reserved.
IDLE
004aab125
43 of 81